My Nikon 1 J2 wont turn on!!?? - Nikon 1 J2 Digital Camera w/10-30mm VR Black

If your batteries are okay (try charging them overnight) it sounds like you'll have to send the camera in for service. Call Nikon Coolpix support at 1-800-645-6687

Here is a link to the Nikon support page which has lots of good info:
https://support.nikonusa.com/app/answers/detail/a_id/238/~/nikon-support-contact-information

If your batteries are okay (try charging them overnight) it sounds like you'll have to send the camera in for service. Call Nikon Coolpix support at 1-800-645-6687

Here is a link to the Nikon support page which has lots of good info:
https://support.nikonusa.com/app/answers/detail/a_id/238/~/nikon-support-contact-information

it may be the internal processor..trouble is unless its a professional series unit..they are made to be disposable..I have a hp small digital that we used for years..it went dead last year..we just did get a new one for christmas..so I am learning it now..

Open your menus and go to the Shooting Menu. Scroll down to ISO Sensitivity.

F15 means : signal lost between oven relay board & EOC(main computer board)

1. Test the harness and connections from EOC connector P16 to oven relay board J2.
2. Replace the oven relay board.
3. Replace the EOC.1. Test the harness and connections from EOC connector P16 to oven relay board J2.
2. Replace the oven relay board.
3. Replace the EOC.

Hope this help. good luck to you.

Please get the driver here : www.samsung.com/us/support/downloads

www.samsung.com/au/.../supportDownloadMain.do
www.nodevice.com/driver/.../Samsung/Digital_Cameras.html
Regards, JAY__GT

There are a couple of solutions, you may not like any of them:

1) get new touch screen :D
2) Check to see if there are any updates to the software / os for the system / drivers
3) Disable, or extend the sleep timer

These are about as simple as it gets, more in-depth solutions may be available, but i would need more information.

i.e.
Software / os versions
model number / manufacturer
system hardware information

Hello sir; After replaced drum need to reset the counter,the procedure as follow;
1, press "clear", "Exposure","clear" "exposure" keys.
2, enter 24, press print key.
it should remove J2.

With "J2" flashing, press:
1. "CLEAR" button
2. "AUTO" button, then again
3. "CLEAR" button
4. "AUTO" button

Do it fairly quickly. If it's done quickly enough the display goes off. When it does:
5. enter "2" and "4" (see "24" on display)
6. Press "START/COPY"
7. Press "7"
8. Press "START/COPY"
DONE

If display doesn't go off repeat steps 1 to 4 but faster, until display is off.

1. turn off XD125f
2. Turn on
3. within 4 seconds press, clear, auto, clear, auto. LED Should go blank,
if not try again
4. use copy quantity keys to enter 24, then push start
5. Again use copy quantity keys to enter 7, then push start
6. turn off
when you restart the cartridge count will be set to zero

I have done this twice and never replaced the drum cartridge.