Question about Heavyduty Jazzy 1121 Standard & Heavy Duty Power Wheelchair

3 Answers

Jazzy 1121 power chair won't go

My mothers has a Jazzy 1121 Power Chair. The chair is fully charged, but does not move. The batties are brand new and charged. What might be the problem? there are 3 red, 4 yellow and 1 green lights flashing far as I can tell. any ideals? thank

Posted by on

  • Anonymous May 17, 2009

    I have a jazzy select. Its completely charged but will not move...the lights just keep blinking 9 times bit wont move at all!!

  • jLAKE Jul 10, 2013

    i HAVE A JAZZY 1121 AND IT CHARGES BUT I GET 3 RED 4 YELLOW 3 GREEN WONT MOVE.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

I find a lot of the controller Problems are caused by the cable running from the joy stick down to the controller gets caught on something or rubbed against something and one or more tiny wires inside are broken ... If I find a spot on the cable that is worn through, that's where I start .. Open up the insulation and check the tiny wires .. fine the broken one and repair it .. usually that solves the problem and saves you a couple hundred for the cable

Posted on Oct 08, 2011

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

It may not be the joystick. I have had the same problem before. The edel cable that goes from the joystick to the back of the wheelchair could be bad. You can try unplugging it and plugging it back into the joystick. Check the prongs on the cable and make sure their not broke. You can also try flipping the switch that is located down by the charger under the chair. The cable is around $200 and the joystick is quite a bit.

Posted on May 16, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

If your chair is run by a Pilot VSI controller, the error code----3 red/4 yellow/ 1 green---indicates a controller failure. I am having controller problems of a different kind on a Jazzy 1107 and it appears that few shops will work on the controller. Replacement is very costly.

Posted on Apr 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a jazzy 1121 and my seat moves around a little bit. How can I lock it?


Pride Mobility Jazzy 1121 - USA TechGuide

www.usatechguide.org/itemreview.php?itemid=570
19 posts - ‎16 authors Medium Back Seat Contoured Medium Back (standard). ... Comments: My jazzyscooter goes forward and side to side but the reverse makes a quick .... Strengths: Tough chair - town I live in doesn't have many curb cuts, but chair will climb ....Maneuvers poorly through (Handicap) doorways, due to rear locked caster wheels.

Nov 29, 2015 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

1 Answer

Jazzy chair yellow light on the power control continues to blink. will not turn off.


yes nplug battery charger in and wait till batterys asre fully charged and turn off,if it doesnt u got water or moisture in the joystick and need a new one

Jan 06, 2014 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

1 Answer

Jazzy power chair's battery runs out quickly afert being fully charged


I had the same problem I had to replace the batteries problem solved.But the batteries are not cheap

Apr 01, 2013 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

1 Answer

Jazzy 1121 power chair won't charge when plug in to charge chair can move when you use joystick


you have either bad batteries or a bad charger or the charger might have come unplugged at the controller or power module. When you have the charger plugged in and you turn on the joystick the lights on the joystick should ripple to indicate the charger is plugged in. If you don't see this ripple then either the charger is bad or disconnected. Trace the charger cable from the rear of the chair (you have to remove the seat and shroud to do this) to the front module and make sure that the cable is plugged in. Hope this helps

Oct 22, 2010 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

1 Answer

Can the speed of the Jazzy Power chair be increased beyond the setting on the armrest remote controller?


Make sure that your tires are properly inflated and that you are not carrying more weight than the power chair will allow and that your batteries are fully charged.
If you got your chair second hand, sometimes the previous owner has the technician change the controller settings to "dampen" it to slow it down to allow them greater response time and control. The technician can reprogram the controller to take it back to 100%. If you got the power chair new, it should be at 100% already.
Take it easy, HotRod. It's a medical device, not a car!
Good luck!

Jul 20, 2010 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

1 Answer

I have a Jazzy power chair on loan and there is no instructiion book. How do I recharge the chair? I know I plug it in but do nmot know if it is actually recharging, Thanks


Be sure to charge the chair at least 8 hours each time. If you use it charge it. If you charge it less than 8 hours than it starts taking away from the life of the battery.

Nov 12, 2009 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

1 Answer

Chair fully charged lrd lights flashing and chair wont move


Try using a Voltage meter to test the Voltage coming from your batteries. Your batteries should be as close to 12v. your motors are 24v. Even if just one battery is bad this can cause alot of headaches.

Jun 20, 2009 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

2 Answers

My Jazzy select wheelchair does not run


you move the joystick and can hear something quicking in the motors

May 17, 2009 | Heavyduty Jazzy 1121 Standard & Heavy Duty...

2 Answers

My Jazzy won't move.


If your batteries are truly charge they should read around 24.5 VDC. And if the freewheel lever is engaged and you still have no movement your probably need to get into a service tech. Also check the circuit breaker on the chair.

Mar 31, 2009 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

We have a Jazzy 1113 Power Chair. The chair is fully charged, but does not move. What might be the problem?


The battery of the chair is dead. It will say its charged but then when you take it off it will die.

You have to replace the battery.
I had the same exact problem with my father.

Dec 30, 2008 | Pride Jazzy 1113 ATS Indoor Power...

Not finding what you are looking for?
Heavyduty Jazzy 1121 Standard & Heavy Duty Power Wheelchair Logo

4,105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heavyduty Health & Beauty Experts

Robin Hill
Robin Hill

Level 3 Expert

1263 Answers

wcdoc1953
wcdoc1953

Level 2 Expert

278 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Are you a Heavyduty Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...