TURNS ON, DOESNT COMPLETE WASH CYCLE, THEN TURNS OFF

Drain pump is probably jammed and not pumping.

dish placement blocking the flow

Jim try running a dry,meaning without a load. see if it works all features to full cycle.

sound like wash heater failure if it doesnt reach wash temp it will jump back to beginning of heat phase,thats why you get a lot of foam heat will suppress this as part of the wash action.

Your washer has a lid switch. If the switch is broken the washer will not spin. The pump is mounted on the motor.
In the wash cycle the pumps turns counterclockwise. In the spin cycle the pump turns clockwise, forcing the water out of the machine. So if that lidswitch is dead then she won't pump OR spin. This video shows how to get into your machine and the next one shows how to replace the lid switch
Use this GUIDE to help you

Did I help?


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

wigwag needs replaced

IT SOUNDS AS THOUGH ITS NOT HEATING IF IT DOESNT IT STAYS IN WASH MODE AND WONT COMPLETE CYCLE NEW HEATER REQUIRED

sounds as if your brake pads have broken, try removing the lower acess panel you should see the broken pads lying somewhere under the machine(at least pieces of them), i bet if you spinn the machine the drum doesnt come to a complete sudden stop after lifting the top( it should if the brakes are engaging

FIX YA IS A JOKE I WOULD LIKE TO BURY THE ************** WHO CREATED IT!

what brand washer? if lidswitch is bad most washers will not drain and spin to move to the next cycle