Question about E-Machines eMachines Monitor E15T4

Open Question

Power Problem with the E15T4B

Basically, My monitor will stay on for the most part, but when i try to change the brightness or even open up the monitor menu, the monitor just turns off. I have to unplug it and wait a few seconds, then plug it back in and it will turn on again. It also shuts off whenver i put the computer to sleep

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Monitor Switched Itself Off, Won't Turn Back On

If you have another monitor at home, try the other monitor. If not, take your computer to a friends house and try their monitor. I have a similar problem with my Compaq Presario SR1120NX. It turns on fine, then after a while screen saver kicks in, turns off monitor. Monitor status light turns amber. I move the mouse and it never turns back on. Have to hold power button down, then turn back on to get video back. Any suggestions?

Posted on Apr 06, 2007

Ad
russolini
  • 47 Answers

SOURCE: Monitor show picture for a few seconds, then turns black

It sounds like the power supply board on your monitor is failing. If it's still under warranty you might be able to get a replacement from the manufacturer - if not, you might be able to have it repaired at a computer or TV repair shop.

Posted on Jun 10, 2008

bammbammfran
  • 159 Answers

SOURCE: Emachine 19" Widescreen Flat-Panel TFT-LCD Monitor

Your power/inverter board is in need of an overhaul.
The capacitors are failing and possibly a transistor.
If the screen showed any redness or pink whebn it was working, Then there is a slight chance that one or more of the 4 lightbulbs in the screen was going bad and finally went.
If you take it apart and send me a picture, I may be able to tell by looking at it.
I repair these boards on ebay
bammbammfran

Posted on Nov 06, 2008

  • 1 Answer

SOURCE: monitor screen picture won't stay on for longer than a second

I had the same problem with my eMachine t3418. Site advisor Micromend suggested changing the power supply to more wattage. Very much recommend doing that. I did but it didn't fix the problem. Micromend also advised trying a video card. I bought a cheap vid card and installed it. It worked. Apparently MY problem was in the motherboard and the vid card worked around that. Much cheaper than replacing the computer. I'm NOT a tech. Just sharing my experience with what worked for me. I you have a laptop or a friend does, hook your monitor to it to test that it's okay first though.

Posted on Mar 26, 2009

SOURCE: My monitor will not stay on, it goes on sleep mode

Hi,
Your problem may be due to the sleep button in your keyboard may got struct into when you cleaned your keyboard.
Try to resolve the struct in the keys, if any.
Restart your system and if still your problem persists, then remove your keyboard and restart your computer and try with some other keyboard if possible. Once if you find out that the problem is with your keyboard, then replace the keyboard / service the existing one.'

I hope this is helpful to you. Please provide your ratings.
Thanks

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My monitor has a very bright background that white pages seem hard to read and video quality tends to be poor, even if i adjust the brightness levels it doesn't help...it is an acer AL17171F model,...


If you can fix it your self,open the power supply and look if the capacitors after the chopper transformer are swollen if yes change them,or take it to an tecnician expert to do that for you

Aug 21, 2011 | Acer AL1717 17" LCD Monitor

1 Answer

I would like to reduce brightness on my ASUS VH242H


Actually, the problem isn't with the drivers. Right click on the battery icon in your system tray. Select "Power Options" (NOT Power4Gear eXtreme). On the right panel, select "Adjust the display brightness." Then, select "Change advanced power settings." Scroll down and open up the "Display" box. The options that are affecting your screen brightness on battery are "Allow SmartDimmer to reduce my brightness after," "Have SmartDimmer reduce my brightness by," and "SmartDimmer full-screen video mode." Playing with the percentages in these boxes will affect how your screen brightness adjusts itself. To get my screen to stop re-brightening itself, I changed "Allow SmartDimmer to reduce my brightness after/ On Battery:" to 100%. I then changed "Have SmartDimmer reduce my brightness by/ On battery:" to 0%. Finally, I set "SmartDimmer full-screen video mode/ On battery:" to Maximum Power Saving. This should solve your screen-rebrightening problems even with the 163.44 drivers (I use those too). Please Rate.
Thanks, Anand Fixya

Dec 23, 2010 | ASUS VW193T Monitor

1 Answer

I have a Dell E172FPb flat screen monitor. The


There are two possibilities, one is bad caps in the power supply, number two is shorted out transistors (P/N c5706/5707) in the inverter circuits. Please open it up and report back what you see so we can guide you further, see example fo failed monitors due to bad caps, lamps, etc: http://s807.photobucket.com/home/budm/allalbums

Jan 30, 2010 | Computers & Internet

3 Answers

I have a Dell 1707fp monitor. When I power the monitor on it powers on normally. After a few miniutes, even though the power button is still green the display goes blank. I have tested this on other known...


I just fixed my for less then 1 minute. Here was the problem, when turn on the PC with the monitor connected. The screen appear like normal for about 2 seconds then shut off black but the GREEN power LED stay on, if i press the power off and turn it back on the screen act the same thing.
Here how to fix it, turn off the PC, unplug the monitor power cable then plug it back. The power LED will stay amber. Hold down both brights minus - and plus + same time, turn on the PC, keep hold the - and + buttons press the power button turn on the monitor.
You will see the screen back on, just hold for about 10 more seconds till you see the screen seem to stay on fine then realse them. That's it how i fixed my.....GOOD LUCK

Oct 27, 2009 | Dell E173FP 17" LCD Monitor

1 Answer

Dell Laptop Inspiron 1525, boots up but once booted the screen only stays bright for a few seconds - a minute and the it seems to fade/ become very dim, you can barely see the windows behind it. This only...


Theres a good chance that you have a power settings problem.

goto:
control panel / power options / power schemes
and make sure you dont have quick time out for ac or battery.
even it if looks right, change both. and reboot see if helps

Aug 26, 2009 | Dell Computers & Internet

1 Answer

My acer al1706 only stays on for 1 min then keeps turnng off


hypersonic98, Did you try the flashlight test?? Did it do this yesterday? When was the last time you saw a crisp, sharp, bright, PICTURE-PERFECT image on the lcd screen? How old is the unit?? Have you swapped an old monitor in place to get online? What does the power indicator lamp(led) do? Does it stay "on" or go out, or change color? Have you read any stuff about bad electrolytic capacitors in lcd monitors yet? Do you know about CCF tubes and their power source. Have you some understanding of how a switch-mode-power-supply functions? Get back to me with some info and I will let you know some options that are open to you as a consumer. I'm louie12fix on fixya or lmistyrel@ aol.com
BYE for now..

Apr 13, 2009 | Acer Computers & Internet

1 Answer

Monitor comes on, I can see everything perfect then goes black


"Most" newer monitors will let you know if the are no longer receiving a signal. Sounds like the backlight is burnt out. Try getting a bright (LED works best) flashlight and shining it at the screen at all angles to see if you can see any of what you were doing. If the backlight is on the fritz, either return it on warranty or buy a new one.

Jan 31, 2009 | Westinghouse L2046NV Monitor

3 Answers

Microtek 997M monitor doesn't stay on...


The inverter is the most common item to fail on a LCd monitor. Capacitors usally fail the most. Are the tops of any of them popped up. If you had any shorted transistors the fuse would probably be blown. Usally labeled F1. I would replace all the capacitors first and go from there. Capacitors are cheap.

Jun 20, 2008 | Computers & Internet

2 Answers

Dell 2407 a04 Turns on (for 2 seconds) then off


your pc may be set to a resolution that is out of range for the monitor. Boot into "Safe mode" reset the Display settings to 640 x 480. reboot into normal mode then change the screen settings to your desired resolution.

Sep 07, 2007 | Dell UltraSharp 2407WFP 24" LCD Monitor

2 Answers

Monitor powers up/flashes on briefly, then screen goes black


See the best solution on: http://www.fixya.com/support/t116490-monitor_shuts_off_but_green_light_stays It worked for me!

Jun 20, 2007 | Dell E173FP 17" LCD Monitor

Not finding what you are looking for?
E-Machines eMachines Monitor E15T4 Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top E-Machines Computers & Internet Experts

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Alun Cox

Level 3 Expert

2678 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Are you an E-Machines Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...