Echolink test reports UDP 5188 and UDP 5189 indicates no receive.

Access your router with username and password.
Then go to NAT and prot forwarding settings.
Select your port and open TCP and UDP protocol.
Then save settings and restart router.



***If you need any kind of technical assistance you can contact support cell at here

Hello Michael Yancy,

Seems to be a bit dated... but the AMATEURS that have these ... like them.

Those trying to set them up... Not-so-much

see the videos at:
How to set up your Echolink Port Configuration

Port Forwarding For Noobs Linksys Routers

eHAM.net has the best forum (important)

http://www.eham.net/ehamforum/smf/index.php?topic=76200.5;wap2

Sir I have receiver el-3020 it plus I wana to open all code would u like to help me and also tell me how to do upgrade this receiver pla

Did you log into the routher and allow TDP/UDP ports like the documentation says? You have to set up a map for those ports in the router programming.

echolink EL-700 FTA receiver unlocking code please solved it ?

access your router with following link.

http://192.168.1.1
or
http://192.168.0.1

For belkin router http://192.168.15.1

type user nams as "admin" and password as "admin" or blank or "password"

Then go to NAT and prot forwarding .
Select your port and open TCP and UDP protocol.
Then save settings and restart router.
Let me know if you need more assistanse.
Thanks.
then go to NAT

How to set up the ports for Echolink:

1. Go to this page (link).
2. Choose the correct router model (if you don't find it, use a model similar to yours. The setup for all Westell routers is almost the same.)
3. skip the advertisement on the next page (upper right corner)
4. choose "Echolink" from the list.
5. Simply follow the instructions.
6. Voila!

In general:

1. Important!! (and most often the reason why it is not working): Make sure that yourWindows Firewall is not blocking the application (see Control Panel-> Windows Firewall -> Exceptions) (details also here).
2. You have to allow UDP destination ports 5198-5199 between Internet andPC in both directions and allow TCP (source port any, destination port5200) from PC to Internet.

If you have any more questions, just come back and leave a comment - I am happy to help.

Thanks for rating!

First I assume that you simply posted this under "Linksys > WRT" by mistake and you are using a D-Link router.
How to set up the ports for Echolink:

1. Go to this page (link).
2. Choose the correct router model (almost at the end of the page)
3. skip the advertisement on the next page (upper right corner)
4. choose "Echolink" from the list.
5. Simply follow the instructions.
6. Voila!

In general: Make sure that your Windows Firewall is not blocking the application (see Control Panel -> Windows Firewall -> Exceptions) (details also here). You have to allow UDP destination ports 5198-5199 between Internet and PC in both directions and allow TCP (source port any, destination port 5200) from PC to Internet.

If you have any more questions, just come back and leave a comment - I am happy to help!

do port forwarding in that you get it in the modem or router any if the port forwading option is there or not

Echolink uses UDP protocol, you sure you're not opening ports for TCP protocol? There may be other ports that need access as well, google "echolink firewall rules" for more help.