Dsm-312 amber/green light will not change to green. it stays amber and will not turn on. What to do?

Green light usually means your water filter is in great condition . the light will stay on,over time change to amber then red. Red means change filter

Purchase a new remote.

power on, push v/mhz,then set to scroll thru to what you need Turn Dial to make aappropriate adjustments from GREEN to AMBER

when i turn the printer on the light flashes amber several times, then green then repeats flashing amber, and back to green etc. turning it off and back on made no difference. last time it worked normally after being off for a couple of days, but now it is doing that again.

Amber light flashes 7 times, then green for a couple of seconds, then amber 7 times etc.

The amber light means the cover is not closed all the way. Something is preventing the cover from staying latched closed - it's releasing just enough to activate the cover-open sensor. Maybe check if you can see anything broken where the cover latches shut.

Not sure if this will be too helpful...

Hello:

Make sure u replace the lamp cover as the safety switch need to be closed to make the set work. If new lamp did not repair your problem , then it may well be the Ballast Board, Sometimes call the Lamp Driver.

hi i have sorted the problem i went on line of the make of the thomson freeview and their was other people with the same problem and they help me by reading their instrutions on their page now it is working .

1st thing, disconnect everything but keyboard mouse and monitor, see if anything changes.

If the issue persists, ensure that all power and card connections for the motherboard are tight and secure. If you've added RAM or other parts, remove them. Reseat the RAM in the motherboard that came from Dell.

If none of those ideas have any effect on the issue, replace the motherboard.

I don't have the sounder so can't address your question directly, but you can download all Raymarine manuals for your gear directly at www.raymarine.com

You have either the DSM250 or DSM300 digital depth sounder module installed. The C80 is not seeing it.

There is an LED status light on the DSM. For starters, it should be lit either red, yellow or green to confirm it is actually powered on. We are hoping for a green light.

Double-check the cable between DSM and C80 for tightness. Also double-check the DSM's power cable for tightness.

The DSM's are sensitive to voltage level onboard. Make sure the DSM's connections to the circuit breaker panel or battery are tight and clean. Double check with a multimeter the there is 12V DC available to the DSM.

Let me know what you find.