Not Printing I've turned on my printer, and then the green light went off and won't respond to printing requests. I know its still on as I can hear it. Turned it on and off, now the green and yellow light are on but still not responding to any buttons I press or printing requests. Many thanks for your help in advance

Hi, try to fixed the paper cassette tray and the cover it might sensing empty paper.

Hi.
If you had done utility check and they are fine, had you try printing on a stand alone not using a computer. if you can print on a stand alone, there is no problem on the hardware side of the printer because u were able to print on a stand alone. you can focus now on the software side by uninstalling and re installing the driver of the printer and that should work.

HI

Please remove your cartridge and check you remove the all security strip in cartridge.

It is not a computer problem, when your printer won't come to ready. The lights flashing are due to a failure of some sort - electronic, or perhaps a fuser warm up problem. The fact is, whatever the fault, it is cheaper to replace this printer than have it repaired.

1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not, press the Power button once more.
8. Your printer should respond as normal

Is there any blinking of light when the print command given. Any error message at printer display or Computer Screen ?

There is some problem in printing options. Please check and make default setting in the Printer properties. Go to Control Panel --> Select the printer --> Open printer window --> properties --> make them defauls --

During print command check whether the spooling in printer window goes completely or not (if it stop in middle )

Let me know in brief to solve this problem before going to reinstall printer drivers and do not vote till you recieve a good solution for this problem.

My cannon printer no longer responds to any commands. I get 4 yellow blinking lights and then 1 green blinker.

Hello it only a try but could be

1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not, press the Power button once more.
8. Your printer should respond as normal.

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

I thought my printer died on me, but it turned out it was a simple paper jam. The whole printer just locked up because of a paper jam! All I had to do was open the top compartment, remove the toner and get rid of the paper jam

Hi , prnter does not respond within a few seconds , the printing jobs are backlog , it must be delete all or cancelled it , so that the printer can move on.