Question about Alpine CDE-9852 CD Player

2 Answers

Ipod won't play

My ipod's been playing fine for months until the other day. It counts up the tracks but won't play anything. cd player and tuner are fine. tried disconnecting the ipod a couple of times. and my ipod works fine too. any ideas?

Posted by on

2 Answers

Re: ipod won't play

I posted earlier today about i have this problem with mine so i updated my ipod and it sorted it.

Posted on Sep 13, 2007

Re: ipod won't play - Alpine CDE-9852 CD Player Car Audio Receivers

You're absolutely right. thanks!

Posted on Sep 13, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer


put a cd cleaner in your cd player see if that helps.

Feb 16, 2014 | Kenwood KDC-MP435U CD Player

1 Answer

Panel lights up, plays CD, plays iPod, but none of the controls work.

switch off, remove battery and replace it after two minutes. switch on. Goodluck Mark

Dec 03, 2013 | JVC KD-HDR50 Car CD/ MP3 Player

1 Answer

Hi I have a Panosonic CQ-C1405W cd/mp3 player. I can play radio and hear the sound, great! But when I play a CD theres no sound its playing you can skip the tracks watch it counting the seconds and no...

are you using an amplifier? if so, it sounds like you are using the blue wire (power antenna remote turn on) instead of the blue/white wire (amplifier remote turn on) to turn your amp on. the power antenna remote wire turns off when you leave tuner mode.

Mar 17, 2011 | Panasonic Car radio CD CQ-C1110GN CD...

2 Answers

Clarion DXZ385USB will not play from the usb input

It is not compatible. I had the same receiver and mp3 player. according to the Clarion website, an "ERROR 5" is the message for a compatibility problem. You probably got an "ERROR 2"(format problem) when you had the player plugged in and then cycled through the sources(that's how I received the error).

I have since bought an Ipod and the USB input works just fine. Clarion says the deck is MTP compatible, but it will not run a lot of MTP devices. Only Ipods and certain memory sticks. The Creative Zen Vision M is read as an MTP device when it it plugged into anything like a computer, Xbox 360, and the Clarion USB receivers. The Clarion units even attempt to read it as an MPT device, but will not play. It is not an issue with the receiver or the MP3 files. The Creative Vision M is not a compatible device, sorry.

May 29, 2009 | Clarion DXZ385USB Car CD/ MP3 Player

1 Answer

USB and CD Player Stopped Working

Checa en el manual si no activaste un candado con el usb.

Apr 09, 2008 | Kenwood KDC-X591 CD Player

1 Answer

Alpine 9885 - no sound with cd's or ipod

have you fixed it yet? if not try this. your car probably has factory amplified speakers. hook up the remote wire AND the power antenna wire to the blue factory amp wire and it should work just fine

Mar 08, 2008 | Alpine CDA-9885 CD Player

1 Answer

Problem playing CD

Does this CD play in any other unit?
Does your player other CDs fine?

Oct 20, 2007 | Panasonic CQ-CB9900U CD Player

1 Answer

Soundstorm SMP3-100R CD player

I have had this problem before with mine. I found that it was one of the tracks I had on my flash drive was corrupt, I don't remember which track it was but if I plugged my drive in it would play until it got to that track and then it would just swith over to radio or cd. I had the same problem with a cd I had burned a bunch of MP3's on. If you erase your flashdrive, reformat it and then try saving songs to it again that should take care of the problem as long as you find out which file has the corruption in it and you don't put it back on your flashdrive.

May 15, 2007 | Soundstorm SMP3-100R CD Player

2 Answers

Kenwood KDC-2025 won't play CDs

source Changer Error Codes ? E-00: Poor Cable connection. ? E-01: Magazine not properly set in changer. ? E-02: No Disc in magazine. ? E-03: CD does not have selected track number. ? E-04: Disc is dirty, upside down or unreadable. ^^^^ ? E-10: No data is recorded on the MD. The player plays the next disc automatically. ? E-99: Changer malfunction, disc may be caught in machine or changer requires service. I suggest the lens needs a clean, or someone has dropped it and broken the delicate lens mech. Luck

Apr 30, 2007 | Kenwood KDC-2025 CD Player

Not finding what you are looking for?
Alpine CDE-9852 CD Player Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alpine Car Audio Receivers Experts

xxxxxx xxx

Level 3 Expert

4679 Answers

Jose Velazquez
Jose Velazquez

Level 2 Expert

227 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Alpine Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides