Hi, i bought a syma s107 yesterday and it worked fine! Today i crashed a little bit the helicopter and it doesen t work now.
WHAT CAN I DO? HELP ME!
then I turn on the syma s107 and the lights work good, the battery of the joystick are full charged, but when i want to move the wings, they don t work
Help me!
Thanks
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, I had a toilet bowl effect after changing the blades on my s107g. After making sure the shaft was seated properly, I simply adjusted the tension on the screws holding the blades in position and after a bit of trial and error tightening and loosening: it's as good as new!
Make sure the drive shaft is seated properly. Gently, but firmly push it down towards the body both above and below bottom rotor. Also check shaft for any hair, thread or such thing that may be wrapped around it.
Let me know if you're still having issues, and we'll dig a little deeper.
It seems tail motor is not working. S107 knows to come with faulty tail motor.
If you open pilot cabin, you should see blue and red (or green and red) wire. See if they are welded on the motherboard. If they are, then tail rotor is not working properly.
Seems like your controller is not working. Try to change its batteries. With new batteries try the following: 1. Turn the controller ON. Wait until green light stops blinking. 2. Turn the helicopter ON. 3. Give it throttle few times until it starts working.
Sometimes controller can still work even if has a blinking light. But these cases are very rare.
Back and forth movement is controlled by the prop on tail. Hold the helicopter in your hand move the right stick up and down to see if the little prop moves. If it works, then maybe the plastic prop itself... i.e. has a chip in it, or is bent/broken
Had the same problem - the rotors would spin but the helicopter would not take off. Finally tried tightening both screws on the piece just below the Balance bar. I tightened one of the screws about 1/8 turn, and now it works great.
help me pleasee
×