Electronis not engaged while pedaling - Proform 315 Csx Recumbent Bike

What do you mean when you say you fixed the cable. It sounds like the cable broke and you replaced it. Is that correct. If so, did you adjust the free play in the clutch pedal to the manufacturers specification. If you have not done this correctly the clutch will either not disengage, or no engage properly. From your description it appears as though there is n free play and hence the clutch is staying disengaged even when you release the clutch pedal. If this is the case, then try lengthening the cable until the clutch pedal moves with say 25 mm of free movement before anything happens, and try again.

engaging?
you meant dis-engage im sure.
pedal up is engaged,
pedal at floor dis-engages it.
my guess, is the clutch drags unless i push the clutch pedal 100%
to the floor.
1: bad cable is 90% cause. non last this long.
2: no free play is way too loose.
3: broken lever on the pedal top. caused by #1

all fail modes covered here.
http://www.fixkick.com/tranny/clutch/clutch-on-kick.html

Sounds like something with pedal to throw- out bearing. Go to a transmission shop they'll check it for free in most cases!

Your pedal height may be adjustable by a stopper bolt at top of pedal. You would have to check the specification for your car. Most important that the pedal has about a half inch free travel before clutch begins to engage. You need that free play to ensure the release bearing (the throw-out bearing) is not touching the fingers on the pressure plate when not engaged. If it always is touching, it will be rolling around constantly and will go out prematurely.
Your new clutch will allow gear engagement sooner as the clutch pedal is released. I mean gears will engage just as pedal is lifting off from floor. You should notice that difference-the old clutch would have taken longer pedal travel from floor before releasing.

check the safety switches start with the one on the pedal

The gearbox probably has electronis shift lock. It will be controlled by the brake lamp switch.Check the fuse for the brake lamps/horn if that is ok, check that the connector has not fallen off the switch at the brake pedal.
Hope this helps

as you turn on the motor starts running. but when you press pedal there is a clutch that engages. probably the clutch keeps engaged. clutch needs to be set to engage on pressing pedal only.

no either the cable is disconnected from the pedal or it is snapped in either case you can't engage the brake with your hands it requires alot of force

I need more channels. I ONLY get 13 channels, 1-13. I know im supposed to have more... Phillips Consumer electronis: manufacture no# 3210t127a

most likelly you might have an electronis suspension make sure if you do and have it check, sometimes you might see some big black bags and that means you have electronis suspension