Question about Pride New Mobility Legend 4 Wheel Scooter

1 Answer

When pluged in to charge scooter, will not charge

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 88 Answers

Possibly your charger

or batteries or main 10 Amp fuse

Pride may tell you (as they told me) that it doesn't have one, nevertheless I found mine below the floor hatch under the foot mat ... and? It was blown. It's a standard 10 Amp car fuse, it cost a few cents and the problem was fixed.

The provider had said that it was definately my batteries and that he would replace them at €157.00 He didn't seem interested when I told him that they were already new! " One of them will be faulty then" he said.
Find that fuse, it's not in the tiller fuse box - but please don't forget that there is a risk of a power short or a bad electric shock be very careful and/ or get an electrician's help.

Posted on Aug 02, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My gogo elite traveller wont chrage. The charging light isnt on when i plug the scooter in.

Sounds your batteries are to low in voltage for the charger to recognize. Also check the fuse on the battery box, normally a red one 10amps.

Feb 13, 2015 | Pride Mobility Products GoGo Elite...

1 Answer

How do I recharge the battery tried replaceing the fuses but it will not charge

the charging fuse on these is internal inside the battery box
1 carry out a continuity test in this blade fuse for open circuit
2 while open check battery volts is over 11 volt or scooter will drive=o/k if lower will need batteries replaced.
3.make sure your charger is the correct one for this scooter
as go go chargers conector are wired different .so a standard mobility charger wont charge these,as there will be no 24volt at pins 1 and 3 ,

Jan 15, 2015 | Pride Mobility Products GoGo Elite...

1 Answer

Diagnostic light flashing scooter wont go batteries are fully charged

make and modle reqd this is a trip code ,count the flashes between pause will answer what has tripped it if continuas flashing it is in freewheel ohas a electromag brake fail will also do this on some modles if charger pluged in while attempt to drive it

Jan 10, 2015 | Health & Beauty

1 Answer

I got a brand new electric scooter a Mach 1 1600 w but when I pluged the charger in it goes straight on the green light is that normal it ain't been fully charged yet

Hello,please ask who the scooter was purchased from.If you start taking things apart or the like,they could say.You should have came back to us and it could affect your guarantee.I believe going back to the last person you deal with can save a lot of problems,I hope this helped.Colin

Jan 05, 2015 | Electric Health & Beauty

1 Answer

I have a Pride legend three wheeler- I replace the battery charger because it would not charge the batteries. I pluged the new charger into the control module it will charge the batteries. Batteries are...

if I understanding this correctly , you cannot use the scooter why it is being charged, there is a inhibit pin that stops the scooter from being used,
All scooters are designed this way.


Dec 14, 2012 | Pride New Mobility Legend 4 Wheel Scooter

1 Answer

I inherited a go go scooter and have been using it intermitantly. I pluged it in to charge over night and it does not charge.I checked all the connections to the charger, reseated the batteries and still...

Check the voltage on the batteries if they are below 10-15 volts total then they are too low for the charger will not pick up the batteries and they will have to be replaced Hope this helps

Jun 20, 2011 | Health & Beauty

1 Answer

I have the Travel Pal plugged into the charger. The charger has a green light on for electricity being on but there is no light on where it shows it"s charging. And it's not charging.

have yoy checked that the battery is well pluged. meaning possitive with possitive and negative with negative. sometimes grasse is stock on the joints of electricity, so brush them with a metalic brush, that should solve the proble.

Jul 30, 2010 | RTO Mega Motion 3 Wheel Travel Pal Scooter

2 Answers

Battery doesn't charge

i had the same problem so i took the battery out and pluged the moped in and it ran so i knew the battery had a prob then i took the battery out of the canvas case and it had expanded to the point were it almost leaked (exploded battery in other words)

Jul 16, 2009 | Transport Schwinn Rechargeable Portable ...

Not finding what you are looking for?
Pride New Mobility Legend 4 Wheel Scooter Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Health & Beauty Experts

Robin Hill
Robin Hill

Level 3 Expert

1271 Answers


Level 2 Expert

280 Answers

Colin Taylor

Level 2 Expert

347 Answers

Are you a Pride Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides