I have problem viewing my philips 60PP9363H in 1080i

You better buy an Original.

See link:

http://www.ebay.com/itm/REMOTE-CONTROL-FOR-Philips-Magnavox-TV-42MF431D-42MF437B-42MF521D-47MF437B-/290922938518?pt=US_Remote_Controls&hash=item43bc5bc096

unless the unit has a input or source button on it you will need the original remote for this, I doubt a universal will work for this, this is typical of Philips.

This function u can't do it without the tv original remote.Try website like Remotes.com to buy the tv original remote.Than used one of those buttons on the tv remote like View Modes,Picture Sizes,Aspect Ratio,Zooming to do the adjustment for tv screen pictures sizes.

Philips Codes 003-004-008-012-019-062-068-069-075-076-086-087-088-130-1320134-167-183

Please Rate this if it has Helped you!

Here are two tips from www.TvRepairKits.com

"You must have the original remote. If so you can access the convergence screen by hitting the menu key"

grab your TV remote and go to setup. check your input settigs and change them from RBG.

you need to replace both convergence Ics. Post the model number of your set and I will post the correct IC numbers as well as alink where you can get replacements with free instalation instructions. Respond to this same post so I will have access to your symptoms when you post the nodel number.

http://www.remotecodelist.com/remotes/magnavox/Philips-Magnavox_PM525S.pdf
This is the user's manual for a Phillips remote control. There is a list of codes in it. They should be rather universal. There's also instructions as to how to program it. I believe that there is a way to program it without using the codes.

Programming with Code Search

1. Manually turn on the device (TV, VCR, etc.) to be controlled.

2. Press and hold Code Search button until the red indicator stays on. Release the Code Search button.

3. Press and release the desired mode button (TV, VCR, etc.). The red indicator blink, then stays lit.

4. Press the Channel Up button repeatedly (up to 300 times) until the device could be controlled changes channel. The red indicator blinks, then stays lit. If you accidentally overshoot the code required, press the Channel Down button to backtrack through the library until the device changes channel. Pressing Channel Up changes direction to forward again. Press and release the Mute button to install the code.

Hope this helps :)

AM UN TELEVIZOR PHILIPS SI VREAU SA MEARGA TELECOMANADA UNIVERSALA LA EL ,AS VREA SA STIU UN COD PT
TELECOMANA

http://www.remotecodelist.com/remotes/magnavox/Philips-Magnavox_PM525S.pdf
This is the user's manual for a Phillips remote control. There is a list of codes in it. They should be rather universal. There's also instructions as to how to program it. I believe that there is a way to program it without using the codes.

Programming with Code Search

1. Manually turn on the device (TV, VCR, etc.) to be controlled.

2. Press and hold Code Search button until the red indicator stays on. Release the Code Search button.

3. Press and release the desired mode button (TV, VCR, etc.). The red indicator blink, then stays lit.

4. Press the Channel Up button repeatedly (up to 300 times) until the device could be controlled changes channel. The red indicator blinks, then stays lit. If you accidentally overshoot the code required, press the Channel Down button to backtrack through the library until the device changes channel. Pressing Channel Up changes direction to forward again. Press and release the Mute button to install the code.

Hope this helps :)