Question about Icom Radio Communications
REPLACEMENT OF DISPLAY LIGHTS
Posted by Anonymous on
I usually replace all of my radio lamps with Ultrabright LEDs. They come in many different colours and usually fit the same mounting hole as the incandescent lamps. They will need a current limiting resistor in one of their leads, 2200 ohms to 4700 ohms at 1/4 watt works well. Leds are polarized so make sure that you get the polarity correct. Leds are also about 1/10 the cost of a similar incandescent bulb.
Posted on Dec 09, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I am a marine electronics technician with 28 years experience. I have also been a licensed amateur radio operator for the past 12 years. Based on my professional experience with both brands (Icom and Yaesu), I have to advise you to go with one of the Icom units. The Yaesu is a good radio, but Icom's customer support is far superior. I have had no problems dealing with their service department over the years, something I can't say about Yaesu.
Hope this helps.
Posted on May 02, 2009
to store a fcy press BAND to go to your fcy range ie 118.000 airband
dial your fcy ie 127.900(shanwick ocean area control) press and hold V/M for 1 sec, small numbers now blink, dial the memory slot you wish to store into ie 001 then press V/M again for 1sec and this will store 127.900 into mem slot 001. make a list:-
mem number / fcy / mode(am - fm) / station / bank
to prog a fcy into a "bank", press V/M for 1sec - blinking mem numbers - dial mem number ie 001(127.900) press MODE - "bank" flashes past-
-- -- -- -- 001 shows, turn dial to show A-00 this is the first "bank", pressing BAND scrolls through all the alpha "banks" - choose one.. ie A-00 (for airband..) press V/M this puts mem 001 into "bank" A mem slot 00, there are 100 slots in each letter 00 to 99. do this to any fcy you want to scan as a group.
to scan a bank press V/M - small numbers appear -
press BAND to scroll through any "banks" you have created ie A B C D etc (only banks with fcys in will display), press MODE -"bank"- press MODE again and you will start scanning just that "bank" of mem slots.
MODE starts and stops the scan... each letter holds 100 mem slots.. happy scanning!!!
Posted on Sep 28, 2009
Tips for a great answer:
Feb 18, 2018 | Icom Radio Communications
Nov 30, 2013 | Icom IC-A24 NAV/COM Transceiver
Sep 23, 2009 | ICOM Informatique iTECH iQfive iQplus Icom...
Jul 10, 2009 | ICOM Informatique Icom F21GM GMRS Radio...
144 people viewed this question
Usually answered in minutes!