Question about Lands Phones

Open Question

LG IPECS 8012D - Phone not starting up, power supply, no ring tone, no LCD Display??

I unplugged the network cable & power supply to turn the stand over to low my phone as the receiver kept coming off the hook, plugged all back in - and phone wont start up now, tried switching off at wall, checked all wires - still nothing. The is no LCD display, the light in top right corner is lit up red as are DND, Headset, Mute, SPEAKER - there is no dialing tone and none of the buttons work on the phone.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

night71
  • 328 Answers

SOURCE: No LCD Display since battery low and phone switched off!

Try to remove the battery for 10 minutes and plug it back in if fully charged. Sometimes the battery just gets tired and needs a new replacement. Try to unplug it first like I said.

Posted on Oct 26, 2007

SOURCE: MLX-10DP phone thinks there's a headset plugged into it

Try a different phone. The clicker switch could be bad on teh phone.

Posted on Jun 25, 2009

male_28_cam
  • 1555 Answers

SOURCE: MY Polycom SE-220 was working fine, then line one

Can you kindly let me know which is the service provider for your line one and what media you are using for bringing the line upto your polycom i.e. copper based wire or some other media.

Posted on Feb 27, 2011

theswans
  • 7 Answers

SOURCE: Unable to dial out, check voice mail and see call display

Hi at the back of the phone you will see a selectable Hi/Lo/Off switch. Slide the (Ringer) switch to High position or Low position to turn the ringer on. Hi for high volume Lo for low volume.

To prevent hearing any ringing of incoming calls slide the (ringer) switch to the off position but when you ready to accept incoming calls again remember to slide the switch back to either Hi or Low setting. Hope this made sense and helped.

Posted on Jun 13, 2011

  • 277 Answers

SOURCE: M7310 Non-Stop Dial Tone

Intercom button/s provide dial tone when they are pressed. They are required to call other phones on your system.
Sounds like your button is stuck or issue with the motherboard.

Posted on Dec 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Connected to cable box sound no picture reboot left tv on 3 hrs. fine. turned off. 2 hours later turned on now no pic just sound. When the tv is cold no pic. when warm pic. ???


https://www.Abctay.com is an online shop ,
We sell television and electrical accessories,all kinds of TV power supply board, logic board, TV LED screen,
TV LCD screen, mobile phone screen, as well as various types of electronic tools,tv parts power supply,LCD,ccfl ,
LED,OLED,lcd panels,HMI,Inverter,LCD screen,lg screen,display screen,lcd monitor,lg lcd, lg monitor ,flat screen ,
touch screen,hmi,bulb,samsung, innolux ,Mitsubishi,philips, hitachi,auo,innolux,Planar, toshiba, siemens,chi mei,Weinview,
Infineon,industrial LCD,industrial control, sharp monitor,vigor plc,delta, mitsubishi lcd,omron plc,etc

May 13, 2017 | Sony Televison & Video

1 Answer

LG L1730S 17" LCD Monitor


Hi Anand,

You need to check your power options settings and modify it , so that your monitor does not turn off automatically.


If you are using windows xp , go in control panel and then there would be an icon for power options , double click the power options and then you would find settings which read turn off monitor , turn off hard disk etc... select the turn off monitor to never mode or as per your convenience and you would have your problem solved.

Hope this helps.

May 12, 2011 | LG L1730S 17" LCD Monitor

2 Answers

My LG 26LH20 turns itseld off after about 2-3 seconds. TV is a little over 1 yr old. I t happened about 2 months ago and I thought it was the cable. had cable serviced, not the problem. now it's...


Tv turn itself off after 2-3 seconds the tv still audio voices?Yes,than the tv long board that call the LCD inverter board it is dead.Require change the tv long LCD inverter board,this board help the LCD screen panel to have a backlight to produced a picture or 2-3 seconds tv power died completely no power to tv all?Yes,than this problems the tv power supply board it is dying.That the board where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish long LCD inverter board or the tv power supply board for the replacement.

May 09, 2011 | LG 26LH20 LCD TV

2 Answers

I have LG GM205 phone and have 2 problems.\r\n1st


Change profile to silent, then go back into general profile & select 'personalize'. Go to Keypad Tones & turn off, then click back & select 'activate'. You should now have no keypad noise and the phone should ring.

Jun 04, 2010 | Cell Phones

1 Answer

Facilities available in LG KP110


Whats New? LG Bullet KP110 - Stylish and Slim
LG Bullet KP110 Music Phone, the latest version of LG’s bullet series is one of the lowest priced GPRS enabled handset. Few enhanced features of the LG KP110 budget phone are powerful FM Radio & MP3 playback, WAP connectivity, hands-free speaker, inbuilt anti-theft mobile tracker, ability to store 500 phone numbers & 500 messages, long Battery life... Dimension 103 x 46.4 x 13.4 mm Weight 65 g Battery Talk time Up to 4 h, Stand-by Up to 400 h Memory 64MB built-in memory + Extendable memory card (microSD TransFlash) Connectivity GPRS Class 10 (48 kbps), USB Display Size 128 x 128 pixels, 1.5 inches Display Colour CSTN, 65K colors Operating
Frequency / Band GSM 900 / 1800 Browser WAP 2.0/xHTML Colors Black, Red Entertainment FM Radio, MP3 player, Games (builtin + downloadable) Other Features Built-in handsfree, Memo, Calculator, Calendar, Alarm Ring Tones Polyphonic (64 channels) Messaging SMS, EMS, MMS































Feb 19, 2010 | LG KP200 Cellular Phone

2 Answers

Tv screen went blank


sound like the inverter circuit board problem. check & replace back same part# inverter circuit board. hopefully could help!!

Dec 29, 2008 | Vizio L32 32 in. LCD HDTV

1 Answer

BIS 34-D phone - Display window blinks date time beeps multiple times/day


The display will blink if power is cut either by unplugging or if the control system is power-cycled. The cause of the power glitches needs to be located & corrected. Changing the ring tone/cadence depends on which control unit is being used.

May 27, 2008 | AT&T Merlin BIS 10 Phone

1 Answer

Ring tone


1. to set mp3 ring tones...

copy any mp3 file to phone ( via cable or bluetooth )
go to multimedia = go to mp3 = now play the song you want as tone,
when song is playing, select options, and select = set as ring tone

DONE and smile......

2. to set Default sound ring tones...

go to menu = my stuff = sounds =
browse the sound files when you like one , select options, and set as ring tone.....

Done and smile again... hope this helped...

May 13, 2008 | LG KG800 Cellular Phone

Not finding what you are looking for?
Lands Phones Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lands Phones Experts

kakima

Level 3 Expert

102366 Answers

Computer Repairing
Computer Repairing

Level 3 Expert

14641 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Are you a Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...