Question about Yamaha YFL-481 Series Intermediate Flute

1 Answer

Why is D flat sounding weird?

Every time when I start blowing D flay it always goes to some weird sound.

Posted by on


1 Answer

Clean it out and try again

Posted on Jul 25, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Yamaha DD55 set has started making weird crackling noises every time I hit one of the pads. Was fine until I started playing them this morning, sounds quite static when contact is made with pads.

It could be either the internal pickup is coming unglued or the electrical connections need to be re-soldered. If you're not familiar with the process, have it done by a repair shop. You risk causing more damage if you're not careful.

Jul 07, 2015 | Yamaha Music

1 Answer

How do i reset the keyboard to factory settings? It sounds really weird right now

You can normally reset Yamaha keyboards by holding down the highest note while turning on. If you want to do a full factory reset see below - remember this may delete all songs etc you have saved to the keyboard memory.

decdbba2-706f-4a8a-afd1-ac3a6264c7f4.jpg dcd670d5-cf98-45e6-87a4-0591820eb4ef.jpg 2c144414-99a6-4025-960d-eaef496036a3.jpg

Jul 20, 2014 | Yamaha DGX-230 Portable Grand Piano

1 Answer

Why is my akai advd51 not playing music

Please check the format of file you are flaying from USB device if it is one of these supported by your system.MP3-CD
Dolby Digital, MP3, PCM, WMA.If it is correct try to set the audio settings to simulated stereo or stereo out.Your system is a 5.1 system so it is possible that all channels will not be simulated with a stereo source.

May 26, 2012 | Music

2 Answers

My new Bugera 333 212 combo has a weird "ringing" noise on the crunch channel. The noise can be heard on other channels too, but it is loudest on crunch. The noise is clearly mechanical, (it...

Microphonic tubes can be detected by tapping them lightly with a pencil. I cannot find if this uses a spring reverb, but if it does, vibrating the cabinet will get a clanky type sound from the reverb tank. This MAY use a digital reverb however which is immune to that. Next thing is to make sure your guitar can't "hear" the output sound of the amp because the strings can pick up the sound and resonate feeding back into the amp. You can detect if this is happening by quickly dampening the strings and see if ringing gooes away. You probably need 6 to 10 feet of clearance between the guitar and the amp OR put your body between the amp and the guitar. ALWAYS set sound level at safe levels. Get a sound meter and go no higher than 90 Db. I know a lot of near deaf musicians whose careers are near over because of hearing loss using too high level.

May 24, 2011 | Behringer Bugera 333212 120W 3 Channel...

1 Answer

I plug my guitar to the amplifier and i get no sound at all..... only if i press the tunning button turns on & stays on for couple of minutes and then it goes off again....what can i do? P.S.: The...

The tuner on this is weird. It requires three presses of the tune button. Read your manual... One press turns on tuner and passes audio till it times out. A second turns on tuner and kills audio... the third press restores audio... Others have had the same problem understanding this three mode thing and the timeout in the first two modes is confusing when sound disappears.

May 14, 2011 | Takamine EG340CLH Acoustic-Electric Guitar

1 Answer

I have a buzzing noise through my MG50dfx every time I use the foot switch and have changed to the over dive/distorted sound. Any help would be wonderful?

Has it always done this? If it's just a mild hissing sound, chances are it's normal. If it's a loud obnoxious buzz, is your gain cranked all the way up? If it is, turn it down about half way and see if it goes away. If not, take it in to a good guitar store for service/diagnosis.

Feb 22, 2011 | Marshall Mg50dfx 50-Watt Combo Guitar...

1 Answer

I had my TSL100 head running 16ohms out into the 8ohm input of my 1960 slant cab. I had sound for a while then it went out completely. I hooked it up right the next day (16ohm out to the 16ohm input) and...

The transformer is NOT likely to be damaged by what you did. The output tubes would have had a lower impedance presented to them and I suspect they may have got gassy or degraded the cathodes. Those SHOULD have been the first thing to check and change.

What you heard about the fuse blowing if tubes go is NOT always correct. If a tube shorts the fuse may go or if it becomes so gassy that it breaks down and shorts the fuse MAY go.

You will not sense as much power when connected right at the 16 ohms as you did on 8... in fact on 8 ohms the amp would probably try to deliver 50% more. If it could it would be double, but due to overloading 50% is reasonable.

ONLY the output tubes are involved here.

Apr 05, 2010 | Marshall Music

1 Answer

Have 2 Chauvet Intimidator Spots. 1 no longer projects light and the bulb is not the issue. It powers up, goes thur its start up routine but will not light the bulb

This unit got a 24volt lamps that came from a transformer. Usually the ceramic contact of the lamp get damaged and corroded after some time and can be replace. You should test at the same time that the voltage is allright with a multimeter. Most sound shop keep such ceramic in stock because its always broken....

Aug 10, 2009 | Chauvet Followspot 400g with Stand

Not finding what you are looking for?
Yamaha YFL-481 Series Intermediate Flute Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Music Experts

Michial Gueffroy

Level 3 Expert

1138 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers


Level 3 Expert

4340 Answers

Are you a Yamaha Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides