Question about Blenders
All of a sudden my blender stop workink light is working but machine is not working is there any trouble shout i can try
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The thermal fuse is blown. You can buy a replacement from RadioShack for $1.69 You have to remove the old one and solder in the new one. If youre "handy" its very easy. Take it to a repair shop, you pay about the same as a new one. Its too bad that most electronics made today are cheaper to throw away and buy a new one rather than fix them when they break.
Posted on Aug 20, 2008
Posted on May 07, 2009
Using your blade holder, turn the motor from the blade end. 1 or two turns. Tak the blade holder out, Plug in an test Sometimes the brushes in the mototor lose a good contact. SGood Luck -Ned-
Posted on Sep 19, 2009
Pretty much that is what happened to me. I found that the motor has 2 "thermal cut-offs" (SEFUSE 113oC). If the motor heats up even a little, these babies kill your blender. They are thermal fuses. Once they blow, it is over until they are replaced. To fix this, the motor must be removed. The spline gismo on top of the blender unscrews with reversed threads. I suggest unsoldering the lead wires from the power supply board, and replacing when done. The cut-offs are inside the taped on white cloth insulation on the top of the field magnets near the brush assemblies on both sides. I replaced them (both were blown) with 2 of NTE8242 ($1.60 each, 240oC 15A). These are way too hot, but that is what I had on hand. I thought that the electronics were defective at first, and I replaced the entire board assembly with a small/cheap ceiling fan wall switch /speed controller from the hardware store (600W 5A) for $10. The root cause of all of this is that the motor fan is not working. The airflow is blocked by base. I put small extenders on the feet and now there is much more airflow. Only time will tell if this is an effective fix. It appears to me that the device my have started out "nice" when it was designed, but cheapened (probably by middle managers taking bonuses for "improving" the design) many times. The fuse is gone, the case is plastic, etc. It really makes me wonder how it got past UL approval.
Posted on Sep 05, 2010
Tips for a great answer:
Sep 07, 2014 | Cuisinart CBT-500 SmartPower Premier Work...
Aug 22, 2011 | Cuisinart BFP-703CH Chrome Blender
Aug 21, 2011 | Cuisinart CB-600 Blender
Jul 30, 2011 | Cuisinart BFP-703 SmartPower Work Top...
Apr 11, 2011 | Cuisinart CBT-500 SmartPower Premier Work...
Jan 16, 2010 | Cuisinart CBT-500 SmartPower Premier Work...
Sep 19, 2009 | Cuisinart SPB-6 Smartpower 6 Speed Blender
Jun 23, 2009 | Kenmore 204101 Single-Speed Blender
Dec 11, 2008 | Blenders
Aug 14, 2007 | Cuisinart SPB-7 SmartPower Work Top...
Dec 09, 2017 | Blenders
165 people viewed this question
Usually answered in minutes!