Question about Sangean Audio Players & Recorders

Open Question

Sangean DPR-99 Plus power switch bouncing problem

The DPR99+ and similar radios have a "bouncing" power switch problem. When you press"off" after about 2 seconds it comes back "on". Only 5 minutes of playing this silly off/on game is quite enough! Eventually you seem to catch it just right and it stays off. Anybody got the solution, or even a schematic? With only that diagram, I know the right guys to talk to.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: SANGEAN ATS505

try the power switch a few times and more force than usual.

Posted on Jun 03, 2008

Ad
  • 2 Answers

SOURCE: Sangean ATS 606 A Portable Radio

Remove the battery compartment door and the batteries. There should be a small hole marked "reset" under the upper battery cradle. Press (gently...until it clicks) and hold for 5 seconds. Replace batteries and try again.

Posted on Aug 06, 2008

  • 1 Answer

SOURCE: Sangean ATS 803A

Don't be mis-led by the working display. I had the "no power" problem with a working display too. I measured the voltage of the two AA batteries. One was 1.33 volts and the other was only 0.76 volts. Replaced the weak AA and everything worked. I suspect the 'enable' circuitry fails around/below 2.1v.

Posted on Dec 17, 2008

radiorob1
  • 17 Answers

SOURCE: Wiring schematic for Sangean ATS 818cs

Yes, go to:
www.thiecom.de/ftp/sangean/ats818/ats818acs-servicemanual.pdf

Posted on Aug 04, 2009

ironcrossaud
  • 281 Answers

SOURCE: 06 ultra radio no sound from speakers only headset.

Switch is fine. You have a damaged audio circuit caused by vibration. Check the bikes mounting brackets. probably broken. The radio will need to be repaired. www.ironcrossaudio.com

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to open the sangean-dpr-34 to replace the battery


These are two back walls. The upper back wall is pushed down out (sliding). The second back wall is fastened with four screws. Pictures on www.amund.de

Sep 14, 2010 | Audio Players & Recorders

6 Answers

I have a 3 band


try the hard reset method ,that is, remove the battery and then insert the battery and switch the radio on ,it will help you.Otherwise try to tune the radio to required frequency by changing in the settings and try...

Jul 07, 2008 | Audio Players & Recorders

1 Answer

Wiring schematic for Sangean ATS 818cs


Yes, go to:
www.thiecom.de/ftp/sangean/ats818/ats818acs-servicemanual.pdf

Jan 01, 2009 | Sangean ATS 818 AM/FM/SW Radio

2 Answers

Sangean ATS 803A


Don't be mis-led by the working display. I had the "no power" problem with a working display too. I measured the voltage of the two AA batteries. One was 1.33 volts and the other was only 0.76 volts. Replaced the weak AA and everything worked. I suspect the 'enable' circuitry fails around/below 2.1v.

Sep 27, 2008 | Sangean ATS 808A AM/FM/SW Radio

4 Answers

ATS 818 Inoperative


Unplug AC adapter from radio. Remove ALL batteries. Wait 15 min. Reinstall batteries

Jan 17, 2008 | Sangean ATS 818 AM/FM/SW Radio

1 Answer

Power problem


Look at right side of radio. Just above the volume knob is the keypad lock switch. Just switch it to the other postition. Should work fine.

Dec 08, 2007 | Sangean ATS 818 AM/FM/SW Radio

2 Answers

Sangean ATS 606 A Portable Radio


Remove the battery compartment door and the batteries. There should be a small hole marked "reset" under the upper battery cradle. Press (gently...until it clicks) and hold for 5 seconds. Replace batteries and try again.

Aug 15, 2007 | Sangean ATS 606 AM/FM/SW Radio

1 Answer

SANGEAN ATS505


try the power switch a few times and more force than usual.

Sep 16, 2006 | Sangean ATS 505 AM/FM/SW Radio

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sangean Audio Players & Recorders Experts

The Knight
The Knight

Level 3 Expert

74243 Answers

Mark Schmit
Mark Schmit

Level 3 Expert

1915 Answers

Gyula Lacz

Level 3 Expert

483 Answers

Are you a Sangean Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...