I am lost,
i have a 4channel amp bridged into 2 channel,
driving 2x12inch pioneer svc 800watt
what or how do i wire the speakers to get a lower ohm for bigger bass?
how do i series or parallel connect the speakers?
the amp is 8/2 ohm compatible
the woofers are 4ohm only.
PLEASE GET ME TO THE POINT OF ULTIMATE PERFORMANCE THUS ALLOWING ME A GOOD STANDING IN COMPETITION.
MY LAST "BURP" WAS MEASURED @ 138.6 DB.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If it's an aftermarket stereo, there's a small blue wire (accessory/antenna) that goes to the amp. So in essence, you have the large cable going to the battery that powers the amp. However, the small power wire going into the amp tells it when to turn on, by the stereo.
what is the output impedance of the unit - factory specs? use calculations for resistances in series or parallel to get what you want. for example if the amps output is 8 ohms and you have two 4 ohm speakers wire the speakers in series. if your output is 4 ohms and you have two 8 ohm speakers, wire them in parallel to get 4 ohms. another way is if you have one 8 ohm speaker and you want it across the 4 ohm output, find a wirewound resistor that'll take the wattage rated at 8 ohms and put it in parallel so the output sees a 4 ohm load.
first thing 1000@4 means 250w per ch. which means150w usable power.the mode switch is only to reduce rca cables,use 2ch mode if only 1 pair rca available,60hz is a bit low for this amp,90 would work better.