Question about Standard (CRT) Televisions

Open Question

Mitsubishi tv model ck35304 Screen is dark

Tv goes really dark but can still see images. Sound is ok. Any Ideas ?

Posted by on

6 Suggested Answers

  • 163 Answers

SOURCE: tv on with sound but no picture

one that you cant handlel, many of the conponent of the tv can cause this problem, from the power supply to the picture tube but at this point regular people cant check anything in a tv, get a tech and pray to get a good one, beacouse the price of the repair ...good luck

Posted on Aug 07, 2006

  • 556 Answers

SOURCE: philips model ptv915 model # 60P8341a

  • sound  off & on is dye to loose contact in sound section
  •  plz check
  • speaker wire or connector loose.
  • speaker defective.
  • loose contact or print loose in sound section.
  • supply to sound section.
  • sound output ic or print loose.
  • hopr this will help
  • good luck.


Posted on Oct 19, 2007

  • 56 Answers

SOURCE: Mitsubishi WS-55807 Picture goes out ... clicking


Posted on Nov 12, 2007

  • 520 Answers

SOURCE: Logik T.V. model LK-74 - fault: green and purple on screen

Try moving speakers away from the TV.

Posted on Sep 05, 2008

  • 252 Answers


try to fine tune your tv using the remote control, or, if you had knowleged in electronics adjust the sound IF transformer using a wood stick or plastic don't use a metal in adjusting the IF

Posted on Oct 10, 2008

  • 19396 Answers

SOURCE: Sony model # KV32S42. The TV started flashing when

If the TV goes in standby, then it is in protection mode.

Ensure also that the fault is not coming from a faulty receiver box sending
bad signal, check if you get same problem on DVD with no receiver box

Try first leaving the TV power cord unplugged for some times, let say one hour or so.

The flashing light indicates a diagnostic state called protection.
When the TV goes on protection there are only two possible causes.

1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.

2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , starting the flashing light.

If you are in situation one, then the TV will reset just unplugging power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.

If you want to DIY you find parts here,

All: Appliance parts, electronics parts & more from

Encompass Parts Distribution

LCD/Plasma Electronic Replacement Parts: Plasma & LCD TVs, Appliances |

On LCD Pay particular attention at inverter and power board, power board can be inspected looking for bulged or leaking capacitors, then tested with a multimeter. The inverter is more difficult to test , there is need to read voltages, should be done by a tech. Also the LCD controller board can cause same problem

On Plasma, test Sustain (Ysus/Zsus) / Buffer boards , cables to plasma, digital board and power board.

On Rear Projection : check lamp, lamp ballast, power board, and convergence.

On CRT TVs, check ballast , flyback transformer, CRT, Tuner, Convergence.

Posted on May 05, 2009

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


1 Points

Related Questions:

1 Answer

I have a Mitsubishi WD-65735 model TV. The screen is getting really dim, or dark. I was thinking it might be the bulb, but want to make sure before I spend the money on it


Yes, it is obviously the bulb. The symptom of your TV is related to that of the bulb. You guessed right.

Go ahead and replace the bulb. Don't fret. It the screen will come back to normal once you replace the bulb.

Your sincerely.


May 14, 2011 | Standard (CRT) Televisions

4 Answers

Screen role red and green wavie lines.

Hello dctc1,

Looks like there is a problem with the convergence IC's. You will have to replace both of them. I would also look for busted capacitors around the IC's.

However, if you are not familiar with TV repairs, I would advise against opening up the set. Best get a service man to come and diagnose/repair the set.

Hope that helps!

Please dont forget to rate or "Accept" the solution if it helped you in any way, or leas you to a fix.

Thank you for using FixYa!


May 18, 2008 | Mitsubishi VS-60607 TV

1 Answer

Image goes out after twenty seconds

my did the same i just hit on the side of the tv and it,s working ok not sure try it.

Apr 03, 2009 | JVC AV-27D303 27" TV

1 Answer

No picture

Are you sure its not a VS60603 ? VS80803 is not a valid model number for mitsubishi. If it is a VS60603 you can get a manual at the following link and they will contact you asking if you would like it emailed instantly. Its 10.99 for the Manual. Heres the link
they have quite a few Mitsubishi as well as other models and they offer free support with the manual.

Jan 23, 2008 | Mitsubishi VS-80803 TV

1 Answer

Screen went dark

can you confirm make and model number please.

Dec 10, 2007 | Mitsubishi WS-55807 TV

1 Answer

Mitsubishi black diamond tv

Might be a bad CRT or bad video output IC that drives the CRT that would cause this issue.

Apr 07, 2007 | Mitsubishi VS-1250 TV

2 Answers

Right 2 inches on edge of screen are darker than the rest of the screen

What is the model of the TV? Samsung DLP TV's start with HLS,HLP,HLW.....

Feb 06, 2007 | Samsung TX-R3080WH 30" TV

1 Answer

TV screen went black, sound OK

check cold solder vertical circuit

Nov 21, 2006 | JVC AV-27530 27" TV

2 Answers


not sure but you could have a bad color wheel i would suggest a service call from your local shop

Jun 07, 2006 | Samsung DLP HL-P5663W 56" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

463 people viewed this question

Ask a Question

Usually answered in minutes!

Top Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66352 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides