Question about Sewing Machines
I have a TMFXII-C1202 tajima embroidery machine and on one of the heads, the needles skip. The do not move all the way down so no sewing occurs. Do you know how to fix it?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Needle won't move on Bernina 930
If the machines motor is running but the needle isn't going up and down then the baste stitch finger is gummed up and needs to be serviced. This is a simple fix and it happens all the time on those machines. Take it to your local Bernina dealer for a standard service. Also if you really need it in a pinch try pushing up on the needle bar that sometimes will fix the problem but it will still need serviced.
Posted on Oct 22, 2007
If you tighten up your needle thread, reduce the tension of the needle thread.
For embroidery, and zig-zag, and because the needle makes side movements, it needs more needle thread.
So try to keep you needle thread not very tight,
and tight up your bobbin case tension more, so that the two threads meet under the meterial.
Posted on Jun 10, 2008
SOURCE: skipping stitches or won't sew
Re-timing is a possible solution but there is a couple of other possible causes. Bent needles are the first thing to check (but you said you changed needles). Another cause in this machine is wear. This machine has been around long enough for the guides for the needle shaft to have worn. You can check this by grasping the needle clamp screw and pushing it front to back. If there is more play than about half the thickness of you thread you're probably going to drop stitches. To verify this is the problem take a piece of string and loop it around the needle clamp screw and pull backwards on it while sewing. If your machine stops dropping stitches you've found your problem and need to take your machine for service.
Posted on Jan 11, 2009
The clutch has fallen off the shaft. Remove the very small screw in the clutch release screw to remove the clutch release. Place the clutch(round thing with ears on it) back on the shaft with the center ears pointing towards the outside. Put the clutch release screw back on. Tighten it to make sure it works
properly. Put the small screw back in the clutch release screw and test it again. If it will not tighten or release properly, remove the clutch ,rotate it180 degrees and try it again.This should solve your problem.
Posted on Feb 16, 2009
SOURCE: skip stitch
The three most obvious causes (other than that of the machine possibly being slightly out of time) are:
1) Too small of a needle size - increase the size.
2) A needle that has a flaw / defect - change the needle.
3) Needle not inserted correctly, either not pushed all the way up into the needle bar, or not installed facing the correct place. On this machine, the small "scarf" in the needle (an indent just above the eye) shouldface the right side of the machine.
Posted on May 07, 2009
Tips for a great answer:
Sep 08, 2016 | Sewing Machines
Sep 30, 2015 | Sewing Machines
Aug 25, 2014 | Sewing Machines
Jul 06, 2017 | Sewing Machines
Mar 27, 2017 | PfaFF Sewing Machines
Apr 28, 2009 | Sewing Machines
Feb 03, 2009 | PfaFF Creative 7570
Aug 17, 2017 | Sewing Machines
850 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: