I suspect this is something to do with the power supply to the motor. Possibly a faulty voltage regulator. You don't say if it's a direct drive or belt driven deck, so can't say more.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It sounds like you normal routine has made the motor hot and then when you slow down the residual heat is causing the motor to cut out. Check the vents in the motor for fluff or blockage.
The pladder motor that spins the dvd disc is failing, or the 5volts to the motor is flutuating, usually the whole assembly is replaced and is expensive.
This is not good, the problem is in the pladder motor that spins the dvd, it has become defective and will need to be replaced in order to correct the problem.
You have a bad door motor. When you wait a few hours and it goes back up slow. The motor has had time to cool off and allows voltage to run thru the motor windings. common problem. You need a new motor. On some models you can remove the door panel and manually move the motor to roll up window.
This dvd player is having a problem with the motor drive circuit. Either the motor is going bad or the drive circuit that supplies the power is failing.The unit need to be taken into a service center for testing and service. The Zenith customer support telephone number is 1-800-243-0000. Give them a call and they can tell you where you can take the unit for servicing. I hope this information will help you with your problem.
Sounds like you have a vertical failure, and is causing the power supply to shut down. A repair person can probably repair this main board in this set but it will cost more in time and labor to repair. So the right thing to do is replace the entire module. This Zenith was designed to replace the boards completely to shorten down time as well as labor. The board this set needs is a 9-02107 module, and is avail from http://www.partstore.com for 52.44 + shipping. I dont think you should attemp to do this repair by yourself if you have no electronics training or tv training. This is just so you know what you need and get an idea on what this will cost you to repair. Good Luck
×