Question about Tomtom GO 700 GPS Receiver
I have not used my go 700 for a month and when i turned on the display, it reach the hand on position and nothing happens...it can be shut only only with reset button. i have tried updating the software too. it did not work. It work in the PC connect mode in the display in my PC.i have tried reseting through the PC but the software reset in the prefence does not get highlighted. Kindly advice
When you get this kind of problem with a Tomtom device always start with the memory card, so: 1: remove the card, clean the contacts and if you have an air duster (available from any good hardware store/electronics store) clean the card slot, then reinsert it. 2: make sure the card is readable on your PC to ensure it doesn't have a problem. if this doesn't help then 3: format the card and reinstall the maps & software on to it. 4: make sure the card is reinserted correctly. Next is the battery, if you've not used it for a month leave it switched on until the battery runs out, switch it on again and it should stay on for a moment then switch its self back off, repeat this until it will not switch on anymore and then charge it for at-least 16 hours before trying it again, this will re-calibrate the battery. Diagnosing a problem is a process and this is just the start of it, don't be disheartened if this doesn't help, just message back with the results.
Posted on Aug 27, 2007
Tips for a great answer:
Jan 28, 2010 | Magellan RoadMate 700 GPS Receiver
Sep 15, 2009 | GPS Devices
Apr 18, 2007 | Tomtom GO 700 GPS Receiver
Mar 19, 2007 | Raymarine ST6001 S1G Hydraulic GPS...
Dec 22, 2006 | Magellan RoadMate 700 GPS Receiver
Oct 24, 2006 | Magellan RoadMate 700 GPS Receiver
32 people viewed this question
Usually answered in minutes!