Logitech How To Setup to my all in one hp computer?

http://ewp.koncon.nl/images/ewp/manuals/mixers/eurorack_mixers843.pdf

Free manual online at the link above:

Looks like both units accept 1/4" jack & I think the 1202 is unbalance out, so just use a standard screened mono (i.e. 2 pole "TS") jack to jack lead & you should be fine. Good Luck! :-)

Use the two balanced outputs, intot he inputs on the back of the speaker, 1/4 inch jack should fit.
Alternativly you can do the same via xlr, for a balanced connection.

That is what is connected to mine and it works great.

You'll need to connect both your PC and the Mic to the mixer, you'll need phantom power switched on at the mixer for the mic to work, you then take the two track out to the Aux input on the receiver.

Hi Brian User Manual for your UB1202

Sorry, the Xenyx1202FX does not have a footswitch input. I would suggest if this function is needed to use an external FX unit which has a footswitch input.

Behringer uses 4580's in appropriate packaging everywhere. There are 339 comparators for the level indicator area.

The Mackies uses both NJM2068 and NJM4560M

The 2068' are used in most of the low noise areas and the 4560 is used in the 75Hz high pass filter for example.

Most Behringer effects are done with the same DSP unit. If you can find the lst for one, it will likely be the same for your unit.

My PMP5000 has the list right on the face. I don't know how to capture the list but I might be able to photo it.

I have searched and it doesn't seem like there is any documentation readily available.

The Ipod is stereo and your speaker is not, so don't expect stereo.

Find a 1/8 inch stereo cable that splits the two channels into individual cables and enter those into two channels of the 1202 mixer. You might find a cable that goes from the 1/8 inch stereo and splits to two RCA type jacks which you have to either find RCA inpouts on your mixer or get two RCA to 1/4 inch adapters.

Crank the pan controls clear to the left on those two channels. Run a cable from the 1202 left main out to your speaker input.

Adjust the controls as needed.