Question about X2Gen MG19MY 19" LCD Monitor

1 Answer

Monitor Failure After an electrical storm my monitor would not come on. The green LED light is flashing and you can see a faint hint of the unit lighting up but goes back out. Nothing else on my system was effected by the storm. What could be the problem?

Posted by on

  • Rebel1 Aug 26, 2007

    My unit is less than a year old (bought in Jan. or Feb.) would this be covered by the warranty? Or am I just out of luck?

  • NITA23 Jun 04, 2008

    I HAVE PLUGED AND UNPLUGED ALL WIRES AND REWIRED IT BACK UP AND MONITOR DOESN'T EVEN TURN ON I HAVE HAD IT FOR ABOUT 6 MONTHS

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

Your system was not affected because the PSU can prevent power surges. Your monitor's backlight has went out due to surges in electricity to your monitor. Unfortunately, you can not replace the backlight. I would suggest you buy a new monitor. 19" LCD Monitors has have went down dramatically in the past month.

Posted on Aug 25, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A125 monitor is dark


If your laptop appears to boot up and the hard disk LED flashes, then the problem is probably a back light fault. This can be a faulty inverter or a faulty CCFL lamp. Please click on this link and follow my instructions to identify the fault and possible fix :- http://www.fixya.com/support/r3598095-faulty_laptop_lcd_screen

Feb 02, 2013 | Toshiba Satellite Computers & Internet

1 Answer

Monitor come on for a few seconds then goes black,green signal light stay on green. can you help


the monitor may be losing the back lite. take a flash light or bright light and shine it at the screen after it goes black. can you see a faint picture? if so the back lite has failed. usually the cost of replacement exceeds the cost of a new monitor but there are a couple of web sites that detail the replacement of the "ccfl" cold cathode flouresecent light.

Apr 27, 2011 | Proview PL713B 17" Flat Panel LCD Monitor

1 Answer

The monitor is plugged into the power, and connect...


Guest, You will need to "sub-in" a known-good monitor to prove your pc is working ok! If pc is ok, then plug-in bad lcd monitor and check ( test ) it with aid of a bright flashlight to see if you can see a very faint image of the WIN-desktop being displayed on the now "black" LCD panel. Every owner of "cold-cathode-fluorescent-lamp back-lit lcd monitors should know the "flashlight test" and understand what the results of this very basic test mean. Do some reading in my old (louie12fix) profile to learn how to do test. Hint: The very first thing I would investigate inside the unit would be the unit's "switch-mode-AC to DC-power-supply/ccfl electronic ballast circuit for the top two causes of power supply going into "partial or full" shutdown mode, trying to SAVE itself from a nonrecoverable catastrophic failure. e.g. sparks,smoke, fire!! 12fixlouie

May 20, 2010 | Computers & Internet

1 Answer

Hanns-G HC194 monitor, no screen, led is flashing in green


hello,

The green flashing power led is a standard symptom of a failure in the power supply board. We have an article about how to repair this unit posted on our web site at: http://www.ccl-la.com/blog/index.php/repairing-a-hanns-g-hc194d-with-flashing-power-light/ If you can solder then you should be able to do the repair yourself, if you don't want to do the repair we do offer a repair service, that information can be found here: http://www.ccl-la.com/blog/index.php/service-request-form/

I hope this helps you out, if so please rate our solution.

Buddy
Corporate Computer
www.ccl-la.com

Mar 27, 2010 | Computers & Internet

1 Answer

Viewsoniv VA 902 LCD 19" monitor


If the signal cable is detachable from the monitor, you could try with another cable... Regarding the power, I' not an expert, but if you're familiar with electronics basics, like risks of high voltage, soldering, etc, and you'd like to experiment with the unit, then I can give you some hints.

Mar 19, 2009 | ViewSonic VX900 19" LCD Monitor

1 Answer

Sir Help me with my Compaq monitor MV520 it won't turn the power led flashing orange to green continously


it could be th epower supply and it could be the monitor.
power ON button should not flash orange regardless what you do. it should stay green. then orange. not orange to green to orange.
try the monitor on another PC if you can fine one.
the other thing is are the 2 monitor similar (CRT to CRT and LCD to LCD), you can't mix the the two, they will work but need different video driver to function correctly.

Oct 20, 2008 | Compaq MV 540 15" CRT Monitor

1 Answer

Blank Screen, power light is steady green


have you tried adjusting for the brightness and contrast of the monitor. does any menu comes out if you press any buttons of the monitor except power of course!

Nov 16, 2007 | Samsung SyncMaster 171S 17" Flat Panel LCD...

2 Answers

Power Led (Green) Flashing


Inorder to verify that the problem is with the monitor have you tried the monitor with another CPU could you please try it because it might be a problem with it the signal may not be reaching with monitor

Jul 26, 2007 | Dell E151FP 15" Flat Panel LCD Monitor

1 Answer

Cornea 15" monitor


If possible, try a new video cable. If it does not correct itself with a new cable, the problem is not serviceable. Flat screens do one of three things: inverter will go out (no light), line input board signal failure and power supply low volts on 12v B+.

Mar 28, 2007 | Cornea CT 1503 (Black, White) 15 in. Flat...

Not finding what you are looking for?
X2Gen MG19MY 19" LCD Monitor Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top X2Gen Computers & Internet Experts

jason

Level 3 Expert

905 Answers

Sandy Moore
Sandy Moore

Level 2 Expert

111 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18425 Answers

Are you a X2Gen Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...