Question about Fujitsu Siemens CELSIUS Notebook

2 Answers

Stripes on Display, is there a way to repair?

I Read somewhere on Internet that, it is possible to Repair Displays with Stripes on it. What do you know about that?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi, Yes it is possible. On some Fujitsu/Siemens units that I've worked on display problems could be caused by: 1. the backlight or its inverter; 2. the video card; and/or 3. the LCD display panel itself. Based on your post/description (stripes), I will rule out the backlight. The next bet (though unlike but a possibility) would be the video card which is underneath a covering/lid on the leftmost near the top on an inverted unit (bottom side up). It is normally plugged into a mini PCI slot with 2 clips/lock at both sides. You can try removing, clean the little gold terminals at the bottom and reinsert. If this does not solve the problem, the most likely will be the panel display itself. Original manufacturer's part - guesstimate about 500Euros. Some firms offer swap for less than 100 Euro, still others offer better glossy replacement for under 400 Euro. One such firm is http://www.screentekinc.com. They also have a step by step guide on do-it-yourself repair at http://www.screentekinc.com/lcd-removal-instructions.shtml Hope this be of some help/idea to you. Post back should you need additional information. Good luck and kind regards.

Posted on Aug 25, 2007

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

Your cable connected to your motherboard on your laptop is loose. This will void your warranty, unscrew the screws around the LCD Monitor, stickers may be covering them, Remove Monitor, then, remove and attach the cable connecting to the lower part of your laptop.

Posted on Aug 25, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1998 Pontiac Montana Transport Radio and Temp Displays are out


don't know if you have had any luck yet.. the radio displays on those older gm cars do just simply fail , I have had 4 in that 96 to 99 time frame and each one just quit suddenly. I believe as crazy as it sounds that the display runs thru the radio. gm did this in all their newer cars in 2000 and up ..they use a data cable that runs thru the radio and feeds half the dash ..

May 09, 2014 | 1999 Pontiac Montana

1 Answer

Display has stripes


This is a typical failure mode for this rig. The only repair is to replace the display. Check with Icom, I think they still stock the proII displays, if not, out of a scrap radio is your only hope

Feb 21, 2014 | Icom IC-756PROII Transceiver 3205669

1 Answer

When I open the lens, the screen is dark and displays no image of the object I want to photograph


If you see the display information on modes - but no images of the object and the photos are black - for two reasons:
1. Defective matrix camera (CCD). Require replacement of the matrix, setting the camera after replacement - the setting is only able to engineer Sony service center.
2. Does not work in the camera shutter - to replace or repair the unit shutter in the lens. Repair is possible at any repair workshop of digital technology.
3. If you do not see any picture on the screen - the display is damaged camera - needed to be replaced.

The exact cause and complete diagnosis is possible only after the removal of the camera.

Oct 23, 2012 | Sony Cyber-shot DSC-T10 Digital Camera

1 Answer

I have 3 black stripes on my Zenith 42


Turn off the TV then unplug it. Disconnect the cable connection and clean the terminals. If the stripes still exist, you have a bad TCP (tape carrier package). It is responsible in transmitting color information to the display panel from the X-Drive (A-Bus) Board. This is not an easy repair. Service of an experienced or a qualified technician is recommended.

Nov 27, 2009 | Zenith P42W34P 42 in. EDTV-Ready Plasma...

2 Answers

My LG EnV3 was dropped and now is white when the phone turns on and the internal screen just shows colors. help me please!


Dropping it may have dislodged one of the internal components. I would bring it to the Verizon store and see if they can fix it or give you a new phone.

Oct 27, 2009 | LG enV3 VX9200 Cell Phone

1 Answer

Kodak easyshare mx1063 camera was dropped and display is broken.


Sorry, but Kodak does not sell digital camera parts (except for the wrist strap) to consumers. Your options are basically to either send the camera to Kodak for repairs or purchase a "parts" camera for somewhere like eBay and use it to repair yours.

Mar 21, 2009 | Kodak EasyShare C875 Digital Camera

1 Answer

Monitor displays alternating pattern of pink and blue stripes


It sounds like your video card is failing and you need to find a way to get around it if possible?

Feb 18, 2009 | Sony VAIO VGC-LS30E 1.73GHz Pentium Dual...

1 Answer

Stripes on Display, is there a way to repair?


If you have tried to reload the drivers and the same thing you still have stipes on the display... uuum i sugest change your screen.. normaly when LCD gets stripes no option but to change it.

cheers

Aug 27, 2008 | Fujitsu LifeBook T4210 Tablet PC

1 Answer

3 Stripes on 1 side of the screen


Ask these guys http://lcdrepair.net

Sep 30, 2007 | HP Pavilion zd7020US Notebook

Not finding what you are looking for?
Fujitsu Siemens CELSIUS Notebook Logo

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fujitsu Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18424 Answers

Alun Cox

Level 3 Expert

2678 Answers

Computer Links

Level 3 Expert

2386 Answers

Are you a Fujitsu Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...