Fujitsu siemens plazma tv remote control - Fujitsu Siemens Plasmavision P55XHA30 55 in. Plasma TV

Use another remote or try other tv brand codes they might actually work and not give you full control, start with samsung https://www.6ya.com/mr.mike

Set-up codes to check with Fujitsu brand TVs are, 1052 1192 1061 1345 1005 1408 1142 1195 1027 1051 1274 1231 1210 1110. Buy one remote control which have these setup codes to Fujitsu brand in their code list. If you wish to get more, http://electrohelponline.blogspot.com/ check this link. Setup code list to many popular brand TVs are given. Pull up previous posts there, either by its left side bar, or view it in Timslide option. Select and buy one among them according to availability.

upgrade to xp service pack 3, you may be able to recover your drivers........goods success, meder's tv service

Check the remote control for its infra-red emission. Check it with fresh batteries. Check by pressing all the buttons on it; and see whether all of it generates infrared signal while pressing. If it is found OK, check and replace the infrared sensor inside the TV. If you wish to get some details; check the site linked here. It has details about how to check a remote control; by one among the post. Pull up older posts. If the remote control is found OK; check and replace the infra-red sensor inside the TV. Contact any service technician.
http://electronicshelponline.blogspot.com/
http://schematicscom.blogspot.com/
http://homenol.blogspot.com/
Search the site by type in this key phrase "how to test a remote control "in the "search box at the top right of the display window of the Homepage" to get the related post quickly.

Hello
The backlight bulb at its center has damaged. There will be more than 12 CCFL lamps which comes about the entire length of the screen at the backside of LCD screen to illumiate the screen, ahich in turn adjust its brighness according to the brighness we controls with remote. The center one of your TV is now bad. It can be replaced. You have to open your TV and disassemble the lcd unit to see and replace this lamp. If you are not familier with this work, get it repaired by some experienced service technician. It can be repaired at home. The lamp will have its ratings marked on it. Choose the same rated lamp. OK.

Hello
Setup codes for NEC tV with One for all urc-6131-6 device universal remote control are:
0030, 0019, 0056, 0497
OK.

You need to temporarily remote the CMOS battery from the motherboard to reset the bootup password.

This website should have all the drivers for your machine.
http://driverscollection.com/?H=T3010&By=Fujitsu

Go to the link below:
http://support.fujitsu-siemens.com/com/support/downloads.html

Enter the requested information. It will take you to the download page for drivers. Select the ones you need and download and install them.

Good luck and let me know how it works out.

USE THE S-Video port for connection to the TV Fujitsu Siemens M7405 has only one s-video port