I want to release my ip adress and refresh it hopeing to get fresh ip or diffrent ip adress

wait you using DHCP? What's to stop the computer from releasing the dhcp lease and obtain a new IP besides the 192.168.0.5 that you are blocking?

Use notepad to write the following:
{IP;2,192,168,001,201'}
{IP;3,000,000,000,000'}
{IP;4,255,255,255,000'}
{IS;1,09100'}
{XJ;Termine'}
and print it to your printer
These will change your
IP adress
Gateway
your submask
activate and deactivate the port with an adress at 9100
and at the end display Termin?
respectiveley

it is depends on what you do with it. RENEW-renews your ip adress ALL-gives you your ip info RELEASE-releases your ip

as i remeber, the secruity code is the one that you put before you access a locked internet connection and the passes are usally wpa styled password. you should put go to run>cmd>type ipconfig>and find you ip adress and put your ip on you internet explore. if should directly connect you to the router figuration or the log in your adminstrater and go to security tab or it might be diffrent. find your pass and put it on the dsi. hope it helped.

Start > Run > "cmd" (enter)

type "ifconfig" hit enter

The 192.168.0.1 or rather the lowest number similar to this should be the IP address

the easiest way is to print out a function list on the copier it should give the ip address on the list then open internet browser and input the ip address in the browser nd change the ip address there dont forget to make the ip address static hope you come right

Try to press the reset button with help of any paper clip for 30Secs. and Release it, Take out power cable - plug back in. Open IE page try 192.168.1.1

WARNING: If you are pressing the reset buttono of router - it will take all your settings to default.

Restore it to facgtory default:

Turn off power
Depress the reset button on the bottom of the router.
Keep the reset button pressed and turn the power on.
Release the reset button after 10 seconds.
The default IP should be 192.168.1.1 or 192.168.0.1
Default passwords vary, but it is usually "admin."

Hope this helps,
BReady

Hi,
First, at the command prompt type ipconfig /flushdns. This will purge the dns cache, then type ipconfig /registerdns. This will refresh your DHCP lease and re-register any DNS names.

After trying the ipconfig /registerdns command, wait for about 15 minutes, then check your status and see it your issue is resolved.

If not, try reinstalling your NIC drivers.
Let us know if you need further clarification.
Thanks for contacting fixya.com

The Hughes addresses are 66.82.4.8 and 66.82.4.12.