HOW TO PROPERLY WIND STRING IN SINGLE HOLE COMING OUT OF SPOOL HEAD.I KNOW THE ROTATION.I HAVE VIEWED THE MANUAL ONLINE STILL CANNOT FIGURE OUT THE THE RIGHT ROUTE OF STRING PLACEMENT ON THIS OLDER SPOOL.I HAVE TRYED SEVERAL WAYS AND STRING JUST COMES RIGHT OUT OF SPOOL WHEN RUNNING.DOES ANYONE KNOW A GOOD PLACE TO LOOK AT SOMEONE SHOWING THE EXACT WAY? TY
SOURCE: i have a string craftsman weed wacker an the
Turn the big knob on the bottom LEFT to loosen it in order to access the drum with the line on it.
SOURCE: I received an answer for a 25cc gas trimmer,
The routing of the fuel lines is the same. If you have 3 lines, that means the primer bulb is not directly mounted to the carb, rather it is connected to the carb with hoses.
Line 1. Comes from the fuel filter in the tank (smaller diameter hose) directly to the inlet port on the carb. This is the port that is opposite the diaphragm on the carb. Diaphragm is held on with 2 or 4 screws through a chrome plate. Make sure to leave enough hose so the fuel filter will fall to the lowest point of the tank when it is being used.
Line 2. Goes from the other port on the carb to the short side of the primer assembly.
Line 3. Goes from the longer port of the primer assembly and returns to the tank. Sometimes this line will have a simple coupler on the inside of the tank, but it is optional and its only function is to keep the line from slipping out. If yours does not have this coupler, just leave an inch or two of line in the tank.
*If both ports on the primer are the same length, you can test to see which is pushing air out...that's where line 3 goes.
Good luck!
SOURCE: How do I remove the hassel free head of my
I can get you part way there. Remove the spark plug and shove some clean rope in the cylinder to prevent the engine rotating. Take the front housing off to access the clutch assembly, pull off the black plastic cover from the shaft end, and use a torx wrench to loosen the screw in the end of the shaft. After it's loose, the clutch drum will come right off. Unfortunately, I am stuck now trying to get the rest of the clutch assembly off without damaging it.
SOURCE: how do i disassemble a craftsman string trimmer head to expose the trimmer shaft?
you dont,y7ou need to get the adapter that came with the universal head,if you try to take more than the head off,you will damage it
112 views
Usually answered in minutes!
×