Push buttons stubborn, don't always work

If it has rear heat it will hold approx 4 gal if system is empty should be 2 gal of full strength and 2 gal of h2o I use the auto zone universal extended life it's 5 yrs 150k yellow comes in orange gal jug.

What kind of car is it? When you pump up the breaks if you push hard on the peddle and hold it for a little bit does it go down at all?

Is the water level ok? Check your water temp into the tub. It needs to be a minimum 120 degrees. Check for plugged spray arms. Do they turn freely? Does dishwasher drain completely?

Any of the ice crusher models have had trouble. The chips get into the mechnism and then freezes it up. Suggest you defrost the unit manually (NOT WITH WATER) and then try it.

does the light close when the door is closed??? poosible that the door switch has gone bad. or a bad thermal fuse behind the unit is also a common culprit of this.. its a white thermostat on back of unit behind the panel (-----------------------) approx this long ad white,,

If this is your 1st dishwasher and you have a garbage disposal installed, quite possibly the dw inlet fitting on the disposal still has the knockout in place. Remove the dw drain hose from the disposal and check to see if the knockout has been removed.

Indicates a power supply failure, needs a few filters replaced expect to pay $100-150 Julio [email protected]

Start with the capacitor. It has a funny smell when they go bad. The motor will smell bad as well when it burns up.

Is that everything in your freezer or just in the fridge. Is this a frostfree model. Often if defrost fails in a frost free model then it is unable to duct cold air to the refrigerator side of things. To fix- turn it off for a day or two.

Sometimes dust is accumulated in tv remote receiver sensor. This will give you the malfunction. Because your statement says TV is about 8 yrs old. Better solution is make one general service. If you have remote checker check the TV original remote working or not. We say universal remote, sometimes even technical person does not know how to use. Because in each and every brand and model there is a secret code to initiate the version. So better make one general service and check in your original remote it is working.