Autofry error codes A05

A05 code is over heat error, unit has to be cleaned thoroughly. take unit apart and clean, I use a rag,brush,vacuum and compressed air. .
press the helpful button and check links below on disassembles.

Comfortzone CZinfrared removing cabinet how to

Comfortzone CZinfrared panel removal How to

Comfortzone CZinfrared bulb replacement How to

A05-303 Master disposal error - clean master trash bin and check to see if sensor lever in master disposal path is pushed back

Hold the two buttons on right with power on to reset.

Everytime I turn on the CZ heater, the display reads A05 and then it goes away when i set the temp. As far as I can see and feel, I'm not experiencing any issues with the heating, fan, or thermostat or the extension cord running hot. I'm concerned that something could be wrong or unsafe, with Comfort Zone filing for Chapter 7, anyone know who is offering support or a number I can contact?

we have a MTI-5 Autofry, and the display shows "Basket Can't Find Home". what can you recomend?

The error code that you have received is from the Temperature Circuit. Please call the MTI/Autofry Technical Support team @ 1-800-348-2976 ext.112 and they will help resolve your issue.

Thank you,
MTI/Autofry

The SFE is a code that stands for safety. Typically this happens when one of the push buttons is not pushed in all the way. Check the buttons inside the filters area, make sure the filter cover is on correctly and make sure the door is closed when turning the machine on. If you contine to have problems, please contact MTI manufacturers of the AUTOFRY @ 1-800-348-2976.

The error message is that the oil is not reaching the set temperature in 16 minutes. Please contact AUTOFRY for more technical support. 1-800-348-2976 ext. 112

~Autofry

the thing might be down to an old master stuck to the drum this could cause the faint copies and the missing print.. pull the drum out check under the master.this would also cause the paper to jam on exit. the error is for no master eject check the calmp is free where it grips the master and also the path for the master eject to the waste bin

Indesit Error Messages and Error Codes Indesit Dishwashers

• F10 - Fill or empty time out. Check that the hoses are not kinked, that the taps are on or whether the drain pump or hose is blocked.
• F11 - Heater timed out. The heater has not reached the required level. Book a service engineer.
• F20 - Temperature under range. Book a service engineer. .
• F21 - Temperature over range. Book a service engineer.

Fault codes for Indesit LCD Dishwasher Models

• A01 - Float switch operated - Book a service engineer.
• A02 - Open/Short circuit heater relay - Book a service engineer.
• A03 - Short circuit on thermistor - Book a service engineer.
• A04 - Unable to reach or sense temperature within 70 minutes - Book service engineer.
• A05 - Pressure switch has not been reset - Book a service engineer.
• A07 - Open/Short circuit wash motor triac - Book a service engineer.
• A08 - Open/Short circuit auxiliary wash motor triac - Book a service engineer.
• A09 - Open/Short circuit with main wash traic - Book a service engineer.
• A10 - Open/Short circuit fill valve traic - Book a service engineer.
• A11 - Half load valve traic or alternating motor action - Book a service engineer.
• A12 - Open circuit heater rely - Book a service engineer.
• A13 - Open/Short circuit dispenser traic - Book a service engineer.
• A14 - Drain hose too low causing syphoning. Check drain hose and re-adjust.
• H20 - Check tap and pressure of incoming water.

_uacct = "UA-1207243-4";urchinTracker();