Question about Cobra 29 LTD CB Radio

Open Question

Classic diagram turner+3 mic wiring diagram to a cobra 29ltd classic

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 773 Answers

SOURCE: i want talkback on my cobra 29ltd classic radio

Open the case on your radio. Solder a 100 ohm resistor between the pa jack and ext speaker jack. You can add a switch if you like to turn it on and off. The lower the resistance, the louder the talkback.

Posted on Apr 25, 2009

kd7och
  • 10 Answers

SOURCE: HOW DO I SET THE

http://www.cbtricks.com/radios/cobra/29ltd_29ltd_st_29wx_st/index.htm
29LTD ST Owners Manual

Posted on Jan 13, 2011

  • 2468 Answers

SOURCE: Cobra 29LTD Classic blows fuse

if it blows the power fuse even with the power switch on the radio off andif it has been inadvertently connected reverse polarity as in the red and black wires were hooked up in reverse,there is a polarity protection diode on the board where the power wires enter the unit,and it shorts out to protect the unit it looks like a standard diode with a white band on one end and will show a short in both directions if defective and high resistance in one direction and low resistance in the other direction if good,if it blows the fuse when switched on,then it can be a leaky or shorted audio I.C. mounted vertically on the side of the radio case,usually has 8 or 10 pins in a row soldered to the circuit board or possibly the R.F. preamp or final output transistor on the inside rear panel of the radio next to the coax antenna connector

Posted on Jan 16, 2011

  • 32 Answers

SOURCE: wiring a turner roadking76 to

1-shield/red 2-white 3-blue 4-black yellow N/C

Posted on Feb 20, 2011

anymhz
  • 500 Answers

SOURCE: cobra 29ltd wiring diagram for mic

1ground
2audio
3tx
4rx

Posted on May 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Magnum delta force radio wiring diagram for Mic turner 2pluse 2


Must know the pin out of the transceiver your wiring it too.
like cobras 1.ground 2.audio 3. TX 4. RX... then wire accordingly.(same as the 4 pin exports)..
Use a ohm meter to find the correct wires on your mic switch.
then you know how to wire any mic to any transceiver.
This will work for the turner 2+2

Aug 24, 2014 | Radio Communications

1 Answer

I need the wiring for the mic


Hello,
Here is the wire diagram for several common mics in relation to a 4 pin CB. Most recent 4 pin CB's such as Midland, Cobra, Connex, Uniden, etc can use 4 pin mics. The wiring is actually depending on the mic rather than the CB so long as the CB's are 4 pin as well. Once you go back to late 80's the 4 pin design was a little different. Anything new it is simpler.
Stock Mic 1- Shield (Ground) 2- Yellow (Audio) 3- Red (Transmit) 4- White (Receive)
Astatic - 4 wire 1- Shield 2- White 3- Red 4- Black
static - 6 wire 1- Shield & Blue 2- White 3- Red 4- Black Yellow NC

Daiwa EM-500 Cobra CA Series 1- Shield & Black 2- Red 3- White 4- Blue
Galaxy DC-521S - 4 wire 1- Shield 2- Yellow 3- Red 4- Black
Galaxy CB-660EI 1- Shield & Black 2- White 3- Red 4- Blue
Sadelta 1- Shield 2- White 3- Brown 4- Green
Turner RK56 Road King 1- Shield & Red 2- White 3- Blue 4- Black Yellow NC
Regards, Tony

Apr 07, 2011 | Connex Radio Communications

1 Answer

Wiring a turner roadking76 to a cobra 29ltd


1-shield/red 2-white 3-blue 4-black yellow N/C

Feb 19, 2011 | Cobra 29 LTD CB Radio

1 Answer

Cobra 29ltd CLassic, TX power and audio is ok, volume from spkr is good, squelch works but no cb recieve.


Try a new Mic. Make sure its a working mic. If you have a bad mic, the receive will not work.

Aug 22, 2010 | Cobra 29 LTD CB Radio

1 Answer

I have a Cobra 21- 23 channel CB and the wires pulled out of the plug. The mike wire has red,yellow black,blue,whiteand a ground. My plug has only four prongs to solder to. What four colors do I use?


Hello there
Here is the diagram for you
Cobra 29LTD, 29LTD ST, 29WX ST
Documentation Project
CBTricks.com

TIPS:
You need to have Acrobat Reader version 5 or newer installed to view the files with pdf_1.gif icon.
If the files with jpg.gif or gif.gif icon will not display see the Site FAQ for help on printing, viewing and using this information.
25ltd_st_sm.jpg
Click Picture to See Close-up
cobra_29ltd_st_29wx_st_side.gif 29LTD ST Owners Manual pdf_1.gif
29WX ST Owners Manual pdf_1.gif
DIAGRAMS
29LTD ST Schematic Diagram pdf_1.gif
29LTD ST Schematic Diagram gif.gif
29WX ST Schematic Diagram pdf_1.gif
WX Schematic Diagram pdf_1.gif
29LTD, 29LTD ST, 29WX ST Factory Service Manual pdf_1.gif
Page 1 to 11
Page 12 to 34
29LTD Factory Service Manual pdf_1.gif
29LTD
29LTD Schematic Diagram pdf_1.gif
29LTD Schematic Diagram jpg.gif
29 LTD Classic Schematic Diagram pdf_1.gif(Courtesy of Rick Jackson)



Mic Wiring
Stock
1- Shield
2- Audio
3- Transmit
4- Receive
Astatic (4 wire)
1- Shield
2- White
3- Red
4- Black

Astatic (6 wire)
1- Shield & Blue
2- White
3- Red
4- Black
Yellow NC
Daiwa EM-500
Cobra CA Series

1- Shield & Black
2- Red
3- White
4- Blue
Galaxy DC-521S (4 wire)
1- Shield
2- Yellow
3- Red
4- Black
Galaxy CB-660EI
1- Shield & Black
2- White
3- Red
4- Blue
Sadelta
1- Shield
2- White
3- Brown
4- Green
Turner
1- Shield & Red
2- White
3- Blue
4- Black
Yellow NC

Nov 17, 2009 | Cobra 29 LTD CB Radio

2 Answers

Help with cb radio


Hello there
here is a link for the scematic ok?
best regards michael

  1. Cobra 29LTD ST, 29WX ST 29LTD ST Owners Manual. 29WX ST Owners Manual. DIAGRAMS. 29LTD ST Schematic Diagram ... WX Schematic Diagram. 29LTD, 29LTD ST, 29WX ST Factory Service Manual ...www.cbtricks.com/radios/cobra/29ltd_29ltd_st_29wx_st/index.htm - Cached

Sep 15, 2009 | Cobra 29 LTD CB Radio

1 Answer

I am trying to find a wiring diagram for a telex turner 56 road king to use on my cobra29ltd can any body give me one


Cobra Models: 21, 25, 29, 89GTL, 1000GTL..
Your Mic colors to the Numbers on the Mic Plug are..
Turner:
1-Shield & Red
2-White
3-Blue
4-Black

Jun 11, 2009 | Cobra Radio Communications

1 Answer

The wires came of the plug of my Cobra Road King 58 mic. I need the wire diagram to put them back on.


if you have a cobra radio with four pin input and a turner road king 56 it goes like this. pin one shield and red wire,pin 2 white,pin 3 blue,pin 4 black and tape up the yellow wire it isn't used. the numbers should be on the plug if not look inside your jack on your radio. hope this helped

Dec 17, 2008 | Radio Communications

1 Answer

Astatic 636l microphone Cobra 29ltd classic


pin 1= sh & bl
pin 2= wh
pin 3= red
pin 4= blk
yellow = not used or put on pin 4

Nov 02, 2008 | Astatic 636L Noise Canceling Microphone...

Not finding what you are looking for?
Cobra 29 LTD CB Radio Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cobra Radio Communications Experts

AnyMHz.com
AnyMHz.com

Level 2 Expert

500 Answers

Steve

Level 3 Expert

3287 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Cobra Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...