Question about Kenwood PB-34M, ,TH-22AT,TH-42AT,TH-79A, 9.6v 1000mAh NiMh Pk 2-Way Radio

1 Answer

TH-22AT WITH LOW VOICE

MY TH-22AT HAVE SENT VERY NOISE VOICE, I TRY TO REMOVE MIC CONDENSOR BUT NOT PROBLEM SOLVE

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

REPLACE THE PTT SWITCH, AND ADJUST THE MODULATION TRIMMER.

Posted on Jun 11, 2008

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: KENWOOD TH-22AT WITH LOW VOICE

Drill a hole in the front panel. The mic is behind the front panel. Be careful.

Posted on Aug 13, 2007

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I get the signal but listening very low Listening low noise and the voice is very low


This radio has a mic check. Turn on radio with out mic plugged in when you plug it in the volume should increase.

Possible causes.
  1. Solder or wire in mic cord broken.
  2. Bad switch in mic .....Astatic mics are bad for this

Jan 13, 2011 | Uniden Radio Communications

1 Answer

I hav a microphone problem.Its working properly on my pc,but when when i connect it to my social netwoking site it doesnt work properly,some wired noice comes out th speaker of th one who is listning to my...


Go on mic. configuration and select on microphone use from configuration mic. name and test the mic. On test mic not works mic,is posible to need a driver for mic and need download and install the driver.

Jul 30, 2010 | Computers & Internet

1 Answer

I just today bought a Samson R21S microphone, and I plugged it into my laptop via the laptops microphone jack, and immediately had problems. It cuts off my voice in mid sentence, it wont get half of my...


Not really the mic's fault - just incompatible.
Your Samson mic is a "dynamic" type and the laptop is expecting a "condensor" type.
You could put the mic through a preamp first but easier to exchange for a more suitable type.

Hope this helps.
http://stores.ebay.co.uk/methleykev
http://www.technicsdjuk.com/

Jul 09, 2010 | Samson R21S Microphone

1 Answer

When talking on my Nokia E63, i hear my own voice causing vibration in the phone. In other words, my own voice causes noise in the speaker. Is it a problem with my mic?


Your MIC is having problem. Ucan just open the panel clean the MIC and check if problem continues change your MIC. It will solve your problem.
Regards, Kesav

Mar 03, 2010 | Nokia E63 Cell Phone

1 Answer

I have a Kenwood TH-22AT, 2 meter handheld. I decreased the squelch manually from a 5 down to a 1 to find some weaker stations. In order to put it back where it was, I need a frequency that is not busy....


You apparently have combined my radio problem with someone else's problem with a humidity device or something. My problem with the radio was solved very nicely, and I have the receipt for the payment.

Dec 19, 2009 | Extech 445815 Humidity Meter with Alarm...

1 Answer

C773: Audio -Internal Mic low sound, external not working


please check the settings from control panel->sounds and audio devices , there you can see voice-voice playback and voice recording.. , if not yet solved the problems, then you have to catch Service center

rd
siva

Jun 22, 2009 | Compaq Presario 700 470024-192 Notebook

1 Answer

Unlocking Kenwood TH-22AT


http://www.radiomods.co.nz/kenwood/kenwoodth22.html

Dec 20, 2008 | Kenwood PB-34M, ,TH-22AT,TH-42AT,TH-79A,...

1 Answer

Low sound quality, lot's of noise


the recorder does have two mic settings, hi and low. the high is great for lectures and the low is for personal dictation

Jan 08, 2008 | Olympus VN-2100PC Digital Voice Recorder

1 Answer

KENWOOD TH-22AT WITH LOW VOICE


Drill a hole in the front panel. The mic is behind the front panel. Be careful.

Aug 12, 2007 | Kenwood PB-34M, ,TH-22AT,TH-42AT,TH-79A,...

Not finding what you are looking for?
Radio Communications Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenwood Radio Communications Experts

Jaime Hernandez

Level 3 Expert

2336 Answers

michael galang

Level 2 Expert

138 Answers

Steve

Level 3 Expert

3289 Answers

Are you a Kenwood Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...