Question about Lowrance Elite 5 Color SonarGPS Combo

1 Answer

Problems won't turn on

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 227 Answers

Check the power cord fist with 12 volt test light check pins in plug with tester too see if you have power in pins if so sounds like you got a bad key pad in unit

Posted on Dec 19, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does this mean? My machine is very new & won't drain it won't go through a full cycle & won't spin properly now it's bleeping with this flashing up on it!


Turn off machine and check water waste filter to see if blocked should be at front at bottom of machine or at back,not sure this is the cure but hope it helps

Apr 06, 2013 | Washing Machines

1 Answer

I have a 1999 Gilera Runner 180FXR, New bat 12V 9 amps. Starter turns and spins pinion gear but won't engage starter ring. If it does it turns ver slow or won't turn engine over. In manual it


Yep, not enough amps to engage the starter clutch, and when ti does engage, not enough amps to turn the engine. You need a 12 amp battery.

Nov 17, 2012 | Motorcycles

1 Answer

Driving in 105 degree temp, truck quits! What happened?


If the engine won't crank with compression in the cylinders, either the head gasket has blown or something else major has happened.
You will have to get it towed to a shop.
If it cranks normally but won't start, you have to figure out if it is a fuel or ignition problem.
Did the temp gauge show it was overheating before it died ?

Jun 30, 2012 | Cars & Trucks

1 Answer

My PS2 won't turn on


It's dying. Buy another one off ebay for cheap.

Jun 30, 2012 | Sony PlayStation 2 (PS2) Console

1 Answer

Put in new starter in 2003 ford expodition and it still won't start what can my problem be won't even turn over?


Smart lock? do you have a picture of a red hand on instrument panel? With falcons quite common. Turn & hold key @ start posision, Hit dash upwards on left side of steering colum, If start = faulty smart lock module. I don't know if expodition has smart lock but probably does

Jun 15, 2012 | 2003 Ford Expedition

1 Answer

Won't even turn on. Was flashing cup size lights on left & right and I turned it off and later tried to turn it on and it won't turn on.


Hi,

The problem is often that the machine develops a leak in the hose that is rightover the transformer...the water drips onto the transformer and kills that...then you have no power to run the machine.

Here is a tip that I wrote about this problem...

Keurig OneCup Coffee Brewer will not turn on
heatman101

Sep 13, 2011 | Keurig B100 Coffee Maker

1 Answer

Hello. My 1997 Chevy Tahoe refuses to start. The problems began with a bad fuel pump. I changed. It worked. The fuel pump died again. I changed it again and it has been working. I parked it for two weeks....


Now you have a good battery & a starter that turns over the motor

Have you cycled the key on & off with a fuel pressure gauge on the
fuel rail?

Do you have a fuel filter that isn't over 3 or 4 years old?

Have you checked for spark while cranking ? Use an old plug on the wires,
if you have ignition wires,don't ground the wire without resistance

If you removed the ducting & MAF Sensor it won't start

Tell us what you checked & exactly how that was done.

Jun 09, 2011 | 1997 Chevrolet Tahoe

1 Answer

'04 Kymco Venox won't start. Bought it a few months ago from someone w. about 20,000 miles on it. Always runs good/never had a problem w. it 'til yesterday. Ran outta gas on the road...put more...


Hi Mrcherry99, for this situation I would call my local dealer or reputable shop's service department and inquire about any possible quick fix. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if possible, and give you a written estimate of repairs and answer any specific questions you may have about your issue. Good luck and have a nice day.

May 18, 2011 | 2005 Kymco Venox 250

Not finding what you are looking for?
Lowrance Elite 5 Color SonarGPS Combo Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lowrance Boating Experts

The Knight
The Knight

Level 3 Expert

74106 Answers

Phil Walker
Phil Walker

Level 3 Expert

605 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1667 Answers

Are you a Lowrance Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...