Question about Troy-Bilt Pony Garden Tiller

Open Question

130292 briggs model stratton

Are there ball bearings in the pull start. i found 2 bearings on the floor after attempting to start

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 6468 Answers

SOURCE: My briggs & Stratton won't start. Changed spark plug.

check for spark is there a low oil shut off and the oil level is a little low ?

Posted on Aug 12, 2012


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

3hp briggs and stratton push mower/pull rope does not engage and turn over engine

if its the old 3hp engine then they have a starter clutch fixed to the crank shaft. they have ball bearings inside and can sometimes get stuck or the gears can wear out. you would need a special tool to remove the starter clutch but you can prise off the top plate on the clutch to inspect the internal workings

Sep 07, 2014 | Garden

1 Answer

Craftsman lawnmower

take back get new one handel probably broken

Aug 16, 2014 | Briggs & Stratton Briggs Stratton...

1 Answer

Repair manual PDF for 130292 0803 02

If it is the service manual you can download from here.

For parts look-up you need to use 130292-0803-99.

Feb 23, 2014 | Briggs & Stratton Garden

2 Answers

Briggs and Stratton 5hp starter shaft doesn't engage

use the free sign and encourage people to take it

Apr 12, 2017 | Atlas Translator Garden

1 Answer

Leaking at point of connection between tip and wand

There is a rubber o ring in a groove towards bottom of the snap in connector.This seals around the tip as you insert it. It will never seal without it. The ball bearings you mention are only to hold the tip in place. The sealing goes on down in the coupler

Jul 02, 2010 | Briggs & Stratton Briggs Stratton ORing...

1 Answer

Pull cord on B&S 6.5 HP OHV engine used on water pump occassionally will get "stuck". Cord pulls out 3-4" only, but then starts normally when pulled at later time (eg 2 hours later). Why? Can I correct...

The Sprag clutch need to be oiled.

Remove cover, remove the top part of the sprag clutch you will see some small balls ensure they are not rusty oil the shaft and put back together.

Hope this tip helps.


Dec 20, 2009 | Briggs & Stratton Briggs Stratton Vanguard...

Not finding what you are looking for?
Troy-Bilt Pony Garden Tiller Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Troy-Bilt Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1383 Answers

Jim Parker
Jim Parker

Level 3 Expert

1041 Answers

Cindy Wells

Level 3 Expert

5379 Answers

Are you a Troy-Bilt Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides