Question about Garden

1 Answer

Need carb linkage diagram for tecumseh LEV120 engine

Need the diagram and going to Toro doesn't seem to get you anywhere

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Master
  • 1,917 Answers

Yes or a bad safty switch check the seat the brake and the clucth

Posted on Jun 07, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 163 Answers

SOURCE: Carb and throttle linkage on a Tecumsen LEV120 361015A

You want the spring to hold tension against the governor.

Posted on May 17, 2009

  • 57 Answers

SOURCE: Need linkage hookup diagram for Toro Super

Go to TORO.com and view parts for your model.

Posted on May 19, 2009

rwvanlue
  • 486 Answers

SOURCE: looking for governor linkage set up took apart

cc4d3bd.jpg hmsk linkages

Posted on Nov 22, 2009

Testimonial: "Just what I needed. Thanks"

rycgl
  • 1545 Answers

SOURCE: i need the correct way to connect the governor

this may not apply exactly to your particular model, but it is for Tecumsehs and may get you on the right track:

http://www.angelfire.com/mb2/visitme/mower/tecumseh.html

Posted on Jul 13, 2010

  • 26 Answers

SOURCE: Tecumseh TVS90 43710M 3.5 HP enginge. I was

the rule of thumb applies to your certain problemif you carefully inspect the throttle plate you can view which hole it belongs in by visually looking for any wear or paint removal around the holes the one with wear of use will be obvious

Posted on Aug 01, 2010

Testimonial: "Thanks, I will check that out."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where does the gov rod and throttle rod hook on a 6.5 hp lev120 on a toro recycler 22 lawn mower


gov. rod goes to the hole in the carb. spring goes to the metal tab on front of engine
26256610-jg13hxxvhk0jaxwe0yezbjhu-3-0.jpg

Aug 10, 2016 | Toro Garden

1 Answer

TORO RECYCLER LAWN MOWER MODEL 20017 2006 EDITION


to far away for me to look at it i'm on the east coast

Sep 01, 2012 | Toro Garden

1 Answer

Toro 6.5 tecumseh won't start


replace your spark plug. it takes a Champion J19LM. If you left fuel in your tank over the winter then drain your tank and your float bowl. Add clean fresh fuel and it should go if not you need to clean your carb

May 17, 2012 | Toro Power Lawn Mower

1 Answer

Toro lawnmower model 20027. The engine starts fine, but goes to full rpms. I have closed the throttle with my finger but it goes back to full rpm operation. Everything seems fine on the mower. i just got...


"Most likely you'll have to remove the bowl nut, under the carb's bowl. You'll most likely find varnish in the jet, or maybe water. These are some typical jets, Tecumseh. Briggs, similar" (baymee LehighValleyPA, 2009).

I'm going to try this tomorrow myself!

Aug 27, 2011 | Toro Personal Pace CARB Walk Power Mower

1 Answer

I cleaned my Toro Proline Carburetor and now I can NOT figure out how to re install the linkage. I need a diagram.


That sucks. I know. I'm guessing you have the standard Tecumseh set up that's on all the Toro's I work on (sideways carb setup). I've learned the hard way to take photos; I'll post the one I took. I apologize for the quality; the next one I do, I'll take a high res one but hope this helps ya out. I mean Toro Push Mowers. James
knucklebstr_1.jpg

Aug 21, 2011 | Toro Garden

1 Answer

Need a scamatic of how the spring and linkage mount to the motor down on the left side if your useing the mower there is a linkage attached to the motor and 1 spring and one linkage from the top of the...


If you have a Toro, then you probably have a Tecumseh and most of them I've worked on look something like this:
knucklebstr_0.jpg
Truly hope this helps.
James

Jun 28, 2011 | Toro Garden

1 Answer

Need replacement engine or short block for Tecumseh LEV120-361541B


Tecumseh has gone bankrupt so finding parts and engines has been difficult. i would see if i could find a B&S engine with the same bolt pattern to mount on the deck.

Sep 30, 2009 | Toro Lawn Mower With Toro Power Tools

1 Answer

BROKEN BRAKE PAD UNDER FLYWHEEL ON TORO LAWN MOWER THE ENGINE IS A TECUMSEH MODEL lev120 SPEC 361541b 195cc


If you had replaced the flywheel key & did not engage the saftey bail it would brake the brake. Make sure the bail is engaged befor installing the flywheel.

Sep 23, 2009 | Toro Lawn Mower With Toro Power Tools

1 Answer

Tecumseh hm80 snow blower motor linkage


below is a web site for you to check out the parts at. Hopefully this helps you out. If not, let me know and I will try to get you a better diagram. thanks.

http://www.outdoordistributors.com/pdf/Tecumseh/TECUMSEH-MODEL-HM80-155315N-PARTS-LIST.pdf

Mar 23, 2009 | Tecumseh Horizontal Tiller Engine 8 Hp, 1"...

Not finding what you are looking for?
Garden Logo

Related Topics:

393 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2475 Answers

john h

Level 3 Expert

11173 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...