Question about Garden

1 Answer

Hayter harrier 56 - Garden

Hayter harrier 56 pull start. How do you fix

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 2 Answers

Honda crv clutch snap

Posted on May 06, 2013

  • everett morton May 06, 2013

    honda crv clutch snap can it be ajusted

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 22 Answers

SOURCE: starting my petrol mower

depending on age of machine set the throttle to maximum revs,and pull the starter cord but newer models have a primer button located on carburettor which is locked just under air filter (black or red colour) push it three times( you should hear it inject fuel) and then pull starter cord,some of these engines have a pre-set throttle ,main concern is that if it has not been used for some time you will need to clean carburettor out,replace diaphragm and remember to use fresh fuel(not older than 90 days) this should cure your problem

Posted on Mar 30, 2009

  • 154 Answers

SOURCE: how many turns on the pulley cord before

i would go 4 turns to allow enough for pulling arms length

Posted on Aug 07, 2009

  • 1 Answer

SOURCE: how to fit a drive belt on a hayter harrier lawn

how to fix a drive bit

Posted on Mar 30, 2010

hunter19_46m
  • 7482 Answers

SOURCE: My Hayter Harrier 41 lawnmower starts but keeps

Sounds like you will need to clean your carburetor.
Sometimes you can get by with priming it a few times, and letting it
run a few times like that and it will flush the gunk out of the jets,
but most of the time you will need to rebuild the carburetor.
If the mower is over a couple years old, then I also recommend that you
buy and install a new carburetor repair kit, because the diaphragm will
get hard and that will cause it to be hard to crank.
When you clean your carburetor and remove the jet screws, count the
number of turns it takes to seat the jets from their original position.
That way when you go to put the jets back in, you know how many turns
they were in/out.
Please do not forget to rate me, Thanks
Good Luck, I hope this helped

Posted on May 26, 2010

  • 760 Answers

SOURCE: I have a Hayter Harrier 41 electric start mower that will not sta

Clean carb.clean gas tank,clean carb again.

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil drain on hayter harrier 41


quite likely it is under the desk where the blade is .

Jul 12, 2015 | Garden

1 Answer

Hayter harrier lawn mower why slow going up a slight incline but runs away going down


Indicates lack of power, but that is normal to a degree. Are you saying it's worsened? Start by cleaning thoroughly then drain all fuel and put freshly bought fuel in. Then you can start to fault find if it's still bad.

Jul 15, 2014 | Garden

1 Answer

Mower wiring diagrams


GOGGLE WHAT YOU ASK. A owner's manual has a diagram.

Mar 22, 2014 | Garden

1 Answer

The distance from the coil to magneto,should it be touching or is there a feeler gage setting on Hayter harrier lawn mower 41


hi this should have a gaged gap to be honest i cant remember what it is, but is definitely should not be touching...hope that helps sorta..

Jun 05, 2010 | Briggs & Stratton Briggs Stratton Vanguard...

1 Answer

Starting my petrol mower


depending on age of machine set the throttle to maximum revs,and pull the starter cord but newer models have a primer button located on carburettor which is locked just under air filter (black or red colour) push it three times( you should hear it inject fuel) and then pull starter cord,some of these engines have a pre-set throttle ,main concern is that if it has not been used for some time you will need to clean carburettor out,replace diaphragm and remember to use fresh fuel(not older than 90 days) this should cure your problem

Mar 22, 2009 | Garden

Not finding what you are looking for?
Garden Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

john h

Level 3 Expert

12104 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...