Question about Konica Minolta DiMAGE Z3 Digital Camera

Open Question

Cant switch it on?

Batteries are fine - but I cannot switch it on - although the red light shows on pressing the button?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Danfoss rx1 thermostat shows 'of' ?


Remove batteries from room stat,turn off the electrical supply to reciever unit.
Turn back on the electric to reciever unit,the red light should be on,press the top "manual" button,the green light should come on and boiler should fire (assuming the programmer is in an "on" period)
Press the bottom button,and keep it pressed,then press the top button until the green light flashes,stand about 6 feet away,and refit the batteries to the stat while observing the reciever unit,either the red or green light (cant remember which) should flash to show the 2 units are syncronised.

Another basic test if all seems ok,when turning the stat up or down,when the green light on the reciever unit comes on or goes off,its usually accompanied by an audible "click" ive found,that if this is not happening, the reciever unit does not switch either on or off,may be intermittant.
Replacement is the only cure.
garden led light

Jun 04, 2012 | Garden

1 Answer

Wii system was has power etc. Handheld control has fresh batteries and lights on face of controller do light up when attempts at pressing various buttons. When Wii is turned on-screen on TV shows Wii is...


Press and hold the the red button under the flap on the wii for 30 seconds this will clear all pairings of controllers. Then press the red buton under the wii again and let go immediately now open the battery case of the controller and press that red button uner there and the controller will pair again and it will work the wii

Please vote if you found this info useful

Mar 11, 2011 | Nintendo Wii Console

1 Answer

Cant push the button to put in gear


CHECK MAKE SURE BATTERY FULLY CHARGED IT HAS TO BE 12.5 VOLTS BEFORE THE BRAKE TRANSMISSION SHIFT INTERLOCK SOLENOID WORKS.IF BATTERY POWER GOOD CHECK BRAKE LIGHTS TO SEE IF BRAKE LIGHTS SWITCH IS WORKING.IF NO CHECK FUSE.IF FUSE GOOD BRAKE LIGHT SWITCH IS FAULTY. IT CONTROL THE BRAKE TRANSMISSION SHIFT SOLENOID ALSO THE NEUTRAL SAFETY SWITCH.IF FUSE AND BRAKE LIGHT SWITCH IS GOOD.YOUR PROBLEM COULD BE A FAULTY NEUTRAL SAFETY SWITCH OR BRAKE TRANSMISSION SHIFT SOLENOID FAULTY.

May 05, 2010 | 2001 Chevrolet Cavalier

1 Answer

2001 Saab 93 was having battery issues and EVERY warning is on!


First check all of your fuses with a test light. When you hooked the cables up backwards something shorted and a fuse is blown. Once you replace the bad fuses the lights and everythinmg should go back to normal operation.

Mar 02, 2010 | 2001 Saab 9-3

1 Answer

Bn59 00463 volume works nothing else cant turn on


Step 1: Remove the batteries

Step 2: Press the power button (red button) on the remote control 5 times.

Step 3: Replace the batteries and your remote should work fine.

Oct 20, 2009 | Samsung Televison & Video

1 Answer

LX5 mouse battery warning still flashing with new batteries


Hello

You need to reconnect the mouse.

Please read instructions from Logitech site

Best regards,
Zizzler

Apr 24, 2009 | Logitech 9311570403 Mouse

2 Answers

Camera won't turn on


There was a POWER button.Please press the button.The button will show GREEN.

Dec 14, 2008 | Sony Cyber-shot DSC-W30 Digital Camera

1 Answer

JVC car radio/cd player wont switch on


As a sanity check run a temporary wire directly from the battery positive to the radio. Twist the red and yellow wires together and connect it to the wire from the battery. If this works either your red or yellow wire connection under the dash or to the harness is not hot like you think. Yellow usually goes to a constant 12 volt source (to keep radio memory) and the red wire to 12volts when the ignition is on. In some radios this is reversed. The test I mentioned will determin if the problem is in the wiring or the radio.

Jun 18, 2007 | JVC KD-S570 CD Player

1 Answer

Black screen


you probably just pressed the DISP button on accident (its on the lower right hand corner of the screen) to turn the screen back on, push the DISP button. if that doesnt work, i would get it looked at by people at Canon.

May 03, 2007 | Canon PowerShot A520 Digital Camera

Not finding what you are looking for?
Konica Minolta DiMAGE Z3 Digital Camera Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Konica Minolta Cameras Experts

kakima

Level 3 Expert

102366 Answers

Greg Cann
Greg Cann

Level 3 Expert

1114 Answers

Willem.
Willem.

Level 2 Expert

359 Answers

Are you a Konica Minolta Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...