Question about Fisher and Paykel Fisher Paykel Intuitive Eco Washer IWL15
Machine stuck on drain in rinse cycle, motor running, water has drained but won't progress. Reduced & redistributed load, did not assist. Only way to turn off is at powerpoint. When turned on at powerpoint it continues in drain mode (motor running) lights are off, and when machine is turned on the short wash, rinse light, slow & hold spin lights are on and it beeps every second!
Your motor controller board is faulty
needs repair or new/recondition board.
Posted on Dec 17, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
We had the same problem with our washing machine being full of water and beeping during the rinse cycle. The problem is that the filter, which is located under the washing machine, is plugged with something. Ours was plugged with a cotton swab. You have to tip the washing machine up and remove the filter and unplug it. The filter is in the center of the bottom of the machine. It twists off. I had to get the cotton swab out of inside the machine through this opening.
This machine plugs up a lot - I've never experience this with any other washing machine. Good Luck!
Posted on Nov 07, 2008
It sounds like you need to re programme the
With the machine plugged into the wall and
turned on and the headset turned off this is what
Push and hold down the start button, while doing that you need to then push and hold down the power button.
Hold them down for about 5 seconds, during
which time you may a series of up to 3 beeps.
Then release the buttons.
Turn the machine off and then on again followed by the start button. Allow the machine to then run the complete cycle.
This should correct your problem, if this doesn't then you may need to then look at replacing the computer panels.
Posted on Jun 14, 2009
i found with mine i had the same fault and it only happened on cold ( i only wash with cold and have hot tap turned off) when on spin it would continue to fill and if i turned the tap off and back on it would stop. this means it is a sticky solonoid valve. remover the controle panel. leaver the solonoid coil off the valve. use needle nose pliers in the little slots to unscrew the valve counter clockwise. check rubber isnt split. if it is replace. clean out and re assemble. if the problem persists and you only use cold like i do swap the hot and cold solonoid over. hope this helps
Posted on Nov 19, 2009
Tips for a great answer:
Nov 02, 2013 | Washing Machines
Nov 02, 2013 | Washing Machines
Nov 01, 2013 | Washing Machines
Nov 01, 2013 | Whirlpool Cabrio Washing Machines
Nov 01, 2013 | Whirlpool WFC7500VW Washer
Nov 01, 2013 | Kenmore Front Load Washer
Nov 01, 2013 | Zanussi Washing Machines
Oct 31, 2013 | Maytag EPIC MFW9700S Front Load Washer
Oct 30, 2013 | Beko Washing Machines
Aug 16, 2014 | Fisher and Paykel Fisher Paykel Intuitive...
300 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: