Question about The Times Case Corporation Tractors International Harvestor

1 Answer

Ih tractor I have a Case IH 956XL. I am having problems starting the tractor. I have cleaned the Fuel lift pump filter, replaced the fuels filters. before I started the tractor after replacing the filters I did bleed the air from the fuel line up to the return line on the Bosch Injector pump. It takes at least 4 - 6 goes at starting, before it starts. I have repaired the glow coil connection and when starting, I hold in the Glow Coil button for 30 seconds prior to starting, with no effect on the starting. Can anyone help me look for a solution. Right now I am going to check the injectors.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • The Times Master
  • 42,084 Answers

You will need to bleed air from the injector pump it self. Next to test glo plugs pull from engine and connect a wire to the body to the earth. Turn on ignition and press button for a few seconds and they should glow. If not check for power to the plug

Posted on May 06, 2013

5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

SOURCE: diesel tractor ran out of fuel now it won't start

You have to take the air lock from the fueling system.

Posted on Mar 04, 2010


It be probably in the tank,check the pipe that goes inside the tank.

Posted on Mar 04, 2010

  • 6 Answers

SOURCE: no fuel to the injectors

What kind of tractor

Posted on May 18, 2010

  • 6 Answers

SOURCE: I have a 1990 685 Case IH. 4X4 tractor. It has

something wedged inbetween teeth on gear.
might have to replace the gear... this means chaging all of the gears as they all ware at the same rate, this will cost you a few hundred

Posted on May 19, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Year of tractor by serial number

CaseIH Farmall 45

Provide the serial number to your local Case IH dealer for assistance with the date:

Case IH Dealer Locator Search Find Dealer Near You Case IH

Jun 04, 2017 | Toys

1 Answer

How to prime fuel syystem on Case IH model 40 compact tractor

Every primer I have found is at the fuel filter. All the others, I opened an injector fuel line. Crank it till fuel comes out. Then it will start, Takes a minute, but will.

Feb 13, 2016 | Cars & Trucks

1 Answer

I need a parts diagram for a cav fuel injection pump. Came off david Brown tractor Model 770 A.

Go to case IH parts on line and find your tractor model and pump diagram

Aug 06, 2011 | Diesel Garden

1 Answer

I have an international 460 tractor and i ma trying to find the serial number. All I have found for a number is 10865, but that doesnt fit into and of the serial number references that I have found. Does...

I have a International mid sixties 460 tractor. Have drained fuel, changed fuel line and filter. Carb has been taken off cleaned no issues. Will start and run for a few minutes sometimes longer than others. Seems like there may be an issue with the governer. Any ideas what to try next. Thanks

Jan 15, 2011 | Farmall IH Tractor 460, 560, 660, 2606...

1 Answer

Where is hydraulic filter located on IH 706 Tractor?

right hand side -teardrop shaped cover bolted to side of transmission should only lose a gallon or so of oil when changing

Aug 06, 2010 | Farmall IH Tractor 706, 756, 806, 856,...

1 Answer

I have a Farmall 560 tractor and I want to convert it into a pulling tractor. How do I get the extra horsepower that I need out of the engine.

if its a gas: get ahold of the govenor and harness that power by puttin a lever of some sort and pull that going down the track. if its a diesel then i do want to warn ahead of time that it my result in blowing head gaskets. but check the manual and crank the pump up as far as you want it, ( if you want it stock). but if you want to have it a hot farm mod ( at least im sure of it) put a electric fuel pump before the filters, it just puts more fuel to the pump itself

Jul 01, 2010 | Farmall IH Tractor 460, 560, 660, 2606...

1 Answer

Slow acceleration low on power ih 1206 air filters new, good fuel supply turbo ok

have you checked fuel filters? make sure that fuel shutoff valve is fully open, and that your fuel is clean/water-free,and hasn't cold-weather gelled

Feb 01, 2010 | Farmall IH Tractor 706, 756, 806, 856,...

1 Answer


check the fuek lines for hole and leaks, check the fuel filter and clean if necessary. remove the carbuerator and inspect the gasket; it should be soft and flexible, if it seems hard or brittle replace it. clean the carb with carb cleaner sray (available at any local auto parts store) and compressed air. make sure you get inside the small fuel rail holes.

Oct 08, 2008 | Garden

Not finding what you are looking for?
The Times Case Corporation Tractors International Harvestor Logo

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top The Times Toys Experts


Level 3 Expert

102366 Answers


Level 3 Expert

75814 Answers

ray gallant

Level 3 Expert

42984 Answers

Are you a The Times Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides