Power plug for iTower S1333

A blinking red light on your Sharper Image 7-inch LCD TV usually indicates that there is a problem with the TV's power supply. Here are a few steps you can try to troubleshoot the issue:
1. Check the power source: Make sure the TV is plugged into a working power outlet and that the power cord is securely connected to both the TV and the outlet.
2. Unplug and reset: Turn off the TV and unplug it from the power outlet. Wait for a few minutes, then plug it back in and turn it on again. This will reset the TV and may resolve the issue.
3. Check the batteries in the remote: Make sure the batteries in the remote control are not dead and are installed correctly. If the remote isn't working, it could be the reason the TV is not responding.
4. Contact customer support: If none of these steps work, it may be a hardware issue. Contact Sharper Image customer support for further assistance or take the TV to a qualified technician for repair.
Keep in mind that the exact cause of the blinking red light may vary depending on your specific model of Sharper Image TV, and the manufacturer's troubleshooting steps may differ. It's always a good idea to refer to the user manual or contact customer support for assistance if you're unsure about how to proceed.

chk for loose connection, chk the ipod on heandphone.

Some here, click on the images tab. Sharper image is just the reseller so they appear under different names. Check the voltage.

https://www.google.com/search?q=Sharper+Image+Kneading+Foot+Massager+206997-01+replacement+power+cord

..

open the r.control and clean the keypads with contacts cleaner from dirty, oxide, corrosion and try again.

God bless you

If cord is new and you have to hold the plug at a certain angle where it connects to the set (a socket?) something there is broken, maybe inside where the socket connects to a board etc---with power off and if you are able to open the set safely I would have a good long look.

I also am looking for a replacement power AC adapter cord for a Sharper Image SI601. I tried a radio shack replacement, and it works about 50% of the time.

Thanks!
Chris

On the same side were the turning knob is located, all the way down under the base there is a very subtle slot to plug in your cord.

it's +24DC and -24VDC.

the connector is a 4-pin DIN but hard to locate. Older laptops used the same connector. I'm in the middle of fixing two for some local folks here as well, and I can't locate them on Mouser.com. But I do have two older laptops that I may just use the cord from and repair the SI333 iTower supply for them.

Tim

These are available from a company called lcdpayless on e-Bay.  Here's the link.
http://cgi.ebay.com/17V-AC-adapter-for-Sharper-image-iTower-SM252-speaker_W0QQitemZ360148880080QQcmdZViewItemQQptZOther_MP3_Player_Accessories?hash=item53da8bcad0&_trksid=p3286.m20.l1116

I NEED ONE TOO!!!!!!!!!!!!!!