Question about Frigidaire Electric Dryer

1 Answer

Electrolux I have an electrolux dry model EIED55HIWO and I recieved an E63 code. I toke the dryer apart to check heating element, element was good so I reassemble the dryer and it was not displaying error code. I started dryer, it ran for about 2-5 minutes and stopped and displayed error code e61. What is this code and why would it switch from e63 to e61.

Posted by on

  • Electrolux
    Electrolux May 07, 2013

    Hello again Curtis - What I meant to say was that error codes E61 and E63 could potentially mean the heater relay has short circuited or there is a wiring malfunction. When a short circuit exists, error codes can potentially switch from one to the next. In any event, I would recommend having a service technician take a look at it.

×

1 Answer

  • Official Brand Answer
  • 4,342 Answers

Hello Curtis - Typically, error code E61 indicates a Heater Relay failure. At first the heater was grounded, and now possibly the heater relay. When the heater grounded it could have shorted the relay as well. Generally it is a good idea to have a professional take a look at it to get to the root cause. Cost of parts and technical expertise entailed in these types of replacements can be a bit tricky.

Posted on May 03, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1314 Answers

SOURCE: Frigidaire Electric Dryer error code "dr"

try pressing options and select for ten seconds loc shouls come on then do it again to turn it off also check to see if the door is closing properly and that the door switch is closing and let me know i cant find no dr code so i dont think an error code i suspect it has something to do with the door closing

Posted on Jan 24, 2008

ngfam1
  • 639 Answers

SOURCE: error code E9E

DEAR FRIEND,
ngfam1 here for you!
I am happy to be of assistance!

This is an electronic problem and must be replaced by factory service!
If it happened from th beginning call factory service right away, it's under warranty, you do not pay for it!!!!!!!!
There is no other choice!
If the dryer was 10 years old I would recommend to trow it out and not spend a dime on it! Are you ready to buy a new machine??
If not let service fix it and get back to having clean clothes!

Here is the service company I refer my appliance customers too!
A&E Factory Service
A Nation Wide Company. / Available 24 / 7 for arranging appointments! In the USA.
1(800) 905-9505

If this dryer is 10 years old or more do not spend any money on it!
The new ones are much more efficient! If you have to replace it buy a Speed Queen , it will do 8 loads a week for 25 years!
It's the last washer and dryer I will ever buy!!!! And less expensive than a top of the line unit!


Good luck!
You will be fine now!

Thank You
Bless you,ngfam1
PS. PLEASE GIVE ME A GOOD RATING HERE ON FIXYA.COM BEFORE YOU SIGN OFF!

Posted on Aug 28, 2008

dragonsthatk
  • 547 Answers

SOURCE: LEQ2152ES 2005 dryer shuts off when start us pushed

The belt can be replaced as follows.
1 remove top and front of dryer shell
2 belt goes around drum around motor pully then under tentioner wheel
3 replace front and top of dryer
(top pops off use a slotted screw driver)
Thanx for using Fixya Please take your time to rate me

Posted on Jun 19, 2009

  • 1531 Answers

SOURCE: frigidaire electric dryer aeq7000es1 low heat only code e4a store

this is a door switch issue make sure the door switch is not broken

Posted on Sep 17, 2009

  • 401 Answers

SOURCE: Frigidaire Dryer not drying clothes properly

TRY DISCONECTING THE VENTING FROM THE BACK OF THE DRYER THEN RUNNING IT .POSSABLE THE OUTSIDE FLAPPER STUCK?IM THINKING NOT THE DRYER. GOOD LUCK!

Posted on Jan 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to take front panel off an Electrolux EIED55HIWO dryer?


Good Afternoon Friend,

I understand you want to know how to remove the front panel of your Electrolux dryer, model# EIED55HIW0. Typically, this is not a do it yourself repair, as there are no step by step instruction manuals. I suggest contacting your local authorized technician for further assistance. They have been trained on your particular appliance, and should be able to remove the front panel with ease. Hope this is helpful.

-Best Regards-
WP

Jun 27, 2014 | Electrolux EIED55H Dryer

1 Answer

Electrolux Dryer quit and has a code E 63


Mark, the heating element is underneath the drum, on the left (as facing the front of the unit).

Per the Dryer Tech Data Sheet:
E63 Error Code indicates: [Fault] Heater to Earth Ground [Possible Fault Conditions] Heating element or wiring defective [Possible Solutions] Check heater coils and connections for short circuits to the cabinet. Replace heater and/or wiring and retest.

To open the cabinet is quite difficult, speaking as a non-professional. There may be easier methods than what I used, but I was successful. First I removed all the screws from the back (there are many). This got the top and the back panels removed. The left side (where I could see the heating element was) gave me considerable trouble until I realized I had to remove the door trim to reveal one last screw. Finally got the side off and swapped out the heater. Much much vacuuming for me. I am still trying to figure out how to clean out the bottom of the duct (underneath lint filter), but that's another post.

Also, just in case you don't have the manual and/or need to order parts, I will include a link.

http://www.searspartsdirect.com/partsdirect/part-model/Electrolux-Parts/Dryer-Parts/model-EIED55HIW0/1412/0151200

For some reason, the Sears Parts Direct website lists the dryer as a Gas dryer, which it obviously isn't, as the part in question is very clearly an electric heating element. Hope this helps.

-Nick

Mar 03, 2014 | Electrolux EIED55H Dryer

1 Answer

Electrolux code e63


why was it happening

Dec 05, 2013 | Dryers

1 Answer

Electrolux dryer EIED55HIWO


Hello - Typically 88:88 on an Electrolux dryer indicates a generic power failure code. Try resetting the unit by unplugging it or flipping the household breaker off. Wait approximately ten minutes.

Dec 10, 2012 | Electrolux Dryers

1 Answer

Electrolux dryer e63


Check heater coils andconnections for short circuits to the cabinet. Replace heater and/or wiring andretest.

Jul 29, 2012 | Dryers

1 Answer

E63 code


E63 is for a open heating circuit. could be a problem with the heating element or a sensor gone bad. Check to see if your dryer is under warranty. If it is I suggest you have the manufacturer take care of the problem. If not let me know, and we'll start by checking the heating element.

Feb 23, 2011 | Electrolux EIED55I Dryer

2 Answers

Electrolux dryer has code of E63


Hi

Thanks for using FixYa. Error E63 in your Electrolux Dryer indicates that the temperature inside is too hot/overheating, to start with check the vent and try to clean it. If still it's not resolved then the issue is with the thermal fuse going bad and needs to be replaced. It is mounted to the exhaust duct inside the back cover panel. Please accept the solution if the issue is resolved or post a comment for further assistance.

Thanks

Rylee

Oct 09, 2010 | Electrolux Dryers

1 Answer

Display window says call service and a E63 code


Hi


Thanks for using FixYa. Error E63 indicates heating element or the wiring is defective. To resolve this issue you’ll have to check the heater coils and connections for short circuits to the cabinet. Replace the Heater and/or wiring and retest. Please do accept the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Aug 07, 2010 | Electrolux Dryers

2 Answers

Electrolux dryer error code e63


I have ann E63 code on my Electrolux dryer. THe vent pipe was somewhat clogged but now is cleaned.What do I do?

Jan 02, 2010 | Electrolux Dryers

3 Answers

Dryer shows E63 error code? What is it? Should I call service?


The error code E63 is a high temperature warning

If you dryer is under warranty, take advantage of it. If not it may be a failing sensor or possibly a control board.

Apr 11, 2009 | Electrolux EIED55H Dryer

Not finding what you are looking for?
Frigidaire  Electric Dryer Logo

634 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Tim Whalen

Level 3 Expert

3072 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...