Cant get the table stand off the bottom of my tv!

If you mean the original stand, place the TV LCD panel down on a table that is covered with a soft cloth. Look at the bottom center of the back of the TV and remove the 4 Philips head screws. Once the screws are removed, pull the stand away from the TV. The base can be removed from the stand body by removing another 4 screws that are at the top of the stand body.

See page 12 of the user manual available from the LG support page: https://www.lg.com/us/support/product/lg-42LG50.AUS . The current link to the manual is https://gscs-b2c.lge.com/downloadFile?fileId=KROWM000196216.pdf .

I hope this helps. If you have put a third party VESA stand on the 42LG50, you may have to remove the TV from the stand to reach the mounting plate.

Cindy Wells

Contact the authorized dealer. They can help you to choose one. Electro help

There are 4 screws found in the center bottom of rear plastic back. 2 at top and 2 at bottom - approx 1/2 inch from bottom the 1st 2 will be about 3 inches apart - then directly above there are 2 more. These screws hold the bracket that holds the stand. Once you remove the bracket there should be no parts sticking out further than the actual television and can now be mounted to the wall with a mounting system.

Just try by any authorized dealers for Sony. If not available, check www.alibaba.com

Hi there,
Most flat TV's actually have the stand held on by 4 screws on the back of the TV, not the bottom. Look closely and you should see them down 4 small holes. These hold the stand on. I think what you may have done is taken the bottom plate of the stand.
Hope this helps
TV_Doctors

If you're talking about attaching the stand to the back of this TV, there's 4 screws, 2-about 3/4" long and 2-about 1-1/2" long, they simply screw into the plate to the back of the TV, lay it on a bed (face-down) and the 2 shorter screws go in the top 2 holes and the 2 longer screws go into the bottom 2 holes.

Ren

forget the four holes on the bottom of the stand. Remove the five allen bolts on the back bottom of the tv-not the stand. Yank on stand and metal plate slides out with stand.

Hi.

A slitght adjustment can be made by either screwing on short transparant internal hose on top of floor head tighter or undoing it turn.

Do this on A table as you need to get down to be able to view sole pate movement

Each time you adjust hose stand vac up on the table & pull handle back as if cleaning carpet you must not push head of vac down on the table.

Now look at sole plate usually when they are wrong the sole plate bottom back end tilts up lifting brush from carpet.

Now tap front of head down if sole plate springs back up lifting brush up again adjust hose a bit more.

What you are trying to do is get sole plate as horizontal as you can.

If you really cant get it to pick up dirt any better try fitting new hose they are more sprigier from new,

http://dysonmanuals.llc.nu/

there should be a little plastic button bottom middle of the stand plate on the back of the tv, find this press and slide off the stand

If you lay the TV down on something soft but firm (towel on the floor or counter) put the screen face down on the back you should see 4 screw holes with the an (S) next to them. They are located at the center near the bottom. If you remove these screws the stand should then slide out of the bottom of the TV. Good Luck