Question about Onan Cummins Quiet Diesel RV Generator - 6000 Watts, Model QD 6000

1 Answer

What is fault code 17

Generator will not turn over

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Code 32 what mean

Posted on Mar 17, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What does it mean when check engine light is flashing


get it serviced USUALLY before it blows up

Nov 21, 2015 | Cars & Trucks

1 Answer

What is Code 33 on Onan Generator Model12.5 HDKCB11506B?


You may be reading the code wrong, Code 33 shows up as blink 3 pause blink 3. This means it has a lower level code fault. To access the real code. Press the stop button 3 times fast within 5 seconds and re-post what the code is please. It may blink pause then blink again, that is the lower fault code that will help diagnose the problem.

Feb 10, 2015 | Onan Generator, 4000W, Gasoline

1 Answer

How to clear the code fault on my Onan 4000 generator. What causes a fault & why???


what model is it KY KV need that and Spec. If it blinks 3 times it indicates a lower service fault. While blinking hit the stop button 3 times fast, then read the code. It will blink, pause then blink again and repeat. What is that code and I can help you. IE 4 blinks pause and 3 indicates code 43

Nov 13, 2014 | Watts Onan Portable Generator - 4000 ,...

1 Answer

Model 17 RES spec#GM51561-GAI serial #2234881 - purchased 12-10-08 - the engine loads down and turns off before finished charging - and it does it with breaker on or off and it is intermittent - does not...


If the unit 'loads down" with the breaker off as you indicated, it isn't the load, (unless someone has wired it on the wrong side of the breaker to the home) and is been overloaded. Assuming that is NOT the case you need to check the stator wires to the breaker for ground shorts, especially when the unit warms up. I had a case once where a unit had a bad stator, it would run fine then as it was put under a mild load it would just bog down like overloaded, the stator was heating up and causing a ground fault. Have the unit load bank tested also. I am interested to know what you found?

Sep 22, 2013 | Kohler 17RES 17 kW Generator

1 Answer

Generator code 0094 01


Can you be more specific? what model Kohler is it, Model number KW etc.

Sep 15, 2013 | Kohler Electrical Supplies

1 Answer

Ihave a fault code P0620


P0620 - Generator Control Circuit Malfunctionxicon.jpghttp://engine-codes.com/p0620.htmlForum CodePossible causes- Failed Generator/Belt
- Battery charge
- PCM controlled generator
- PCM failure
- Open or short generator circuit When is the code detected?The PCM has fault detection circuitry which monitors the state of the generator turn on signal circuit. If the fault detection circuit senses a voltage other than what is expected, this DTC will set. The voltage regulator also contains fault detection circuitry. If the regulator detects a problem, the regulator will ground the generator turn on signal circuit, pulling the voltage low. This also causes the PCM to set the DTC.

Nov 05, 2012 | Cars & Trucks

1 Answer

I have a locked rotor fault message.


I had this fault show this morning. Very alarming, as we have a typhoon coming theough tomorrow!

Turned out to be an easy fix. When I hit start the solenoid engaged but nothing moved. Then I saw the fault message and thought "Large $$$$!"

It was just a bad 12 Volt battery, and when it couldn't crank it threw the fault code. I replaced the battery, pulled the 3 fuses on the control panel (mine is the 20 Kw model), and the codes cleared, and she fired right up.

The advice here and on a couple other sites about powering down the panel to clear fault codes saved me a lot of time, money and aggravaion, not to mention a freezer full of food (knowing the Guam Power Authority, and knowing typhoons, the power WILL go down tomorrow.

Jul 27, 2012 | Kohler 14resa 14kw Home Emergency Backup...

Not finding what you are looking for?
Onan Cummins Quiet Diesel RV Generator - 6000 Watts, Model QD 6000 Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Onan Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74243 Answers

Cindy Wells

Level 3 Expert

5126 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you an Onan Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...