Question about American Range Kitchen Ranges

Open Question

Propane range and orfus

The tecs installed a 56 orfus instead of the manufacturer preset 55 to solve a noise problem when the stove was heating. Should I be worried it's too big and there will be gas leaks? Or will there be any problems in the future?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Convert natural gas range to propane

I want

Posted on Jun 09, 2008

  • 198 Answers

SOURCE: Natural Gas to Propane for Ge xl44 Gas range

The kit is located at the rear of the range right near the gas valve, there are probably 5 spuds and an extender for the large burner, directions are with the range. For the bake and broil you will need to tighten the brass orifice nuts down as tight as possible, also the brass nut on the gas valve needs to be reversed
your local LP dealer should be able to do this for you if you are uncomfortable doing it yourself.

Posted on Jan 27, 2009

  • 1 Answer

SOURCE: Converting GE XL 44 Gas range from propane to natuiral gas

I needed parts for my GE XL44 propane converted stove. This site was very helpful. I found the part and there is online live help or toll free help. Go to: AppliancePartsPros.com

Thanks,
nnb704

Posted on Jan 29, 2009

joboo1
  • 257 Answers

SOURCE: Propane gas burner now has red flame instead of blue

Hi, If you have the same problem with your stove , furnace and water heater, Then you look for things in common that would cause the problem. Any change in the flames is an indication of a change in the fuel/air mix. The item that would be common to all would be the pressure diaphragm. This is not something a customer should work on without a through knowledge of how they work. I think you would be well advised to have a service call. Good Luck!

Posted on Feb 10, 2009

mgprice
  • 744 Answers

SOURCE: GE Gas Range Over Won't Heat

Hello, Yes this is going to be the bake igniter. If you remove the lower panel in the oven you will see the bake igniter. It may still be working when you switch on the oven but it is not getting up to the correct temp in order to ignite the gas. Replace the igniter and you will be all set. If you have any other questions please feel free to comment. Good Luck! Mike

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Waterford propane heating stove fan noise


Hi
Just check out for any loose screws or bolts. Maybe the fitting has gone loose, before that check out if anything is stuck in the fan area. Use a blower to clean the area. hope it solves the issue. Dont forget to leave a comment.
Regards,
Javeed

Apr 13, 2014 | Heating & Cooling

1 Answer

I have two magic chef model 6157wuw ranges in my house which operate on propane. The stove burners work perfectly however the ovens produce no heat, no smell of propane and no sign of a pilot or glowing...


It sounds like your propane line is obstructed or your igniter has failed. If your igniter has failed, the propane will not flow until a heat source, from your igniter, has heated a sensor to let the unit know to allow propane to flow. If the propane line is obstructed, it is probably a spider web or eggs from an insect. A pipe cleaner is the best way to remove these obstructions. It would be advisable to have a qualified technician look at your unit.

Sep 21, 2013 | Magic Chef Kitchen Ranges

2 Answers

I need to change the stove to operate on propane instead of natural gas.


You will need to conact a gas safe engineer who will change your gas jets from natural gas to LPG, then carry out various test to makesure your flueless appliance burns the gas safely and efficiently

Jul 11, 2011 | Hotpoint Kitchen Ranges

2 Answers

I purchased a new natural gas range a couple years ago for our cabin. I need this range to use propane.can this oven be changed to use propane instead of natural gas?


should be able to change orifices to propane. some ranges offer these on the back of the stove or you can buy them at a local parts dealer. take your model # with u when you research a part

Jun 22, 2009 | GE Profile Spectra JGBP90 Gas Kitchen...

1 Answer

Toyo 55, igniter gets hardened build-up


Gartyl,

Your Laser 55 burner mat has erroded away. The fuel is pooling someplace in the burner rather than spreading smoothly over the bottom. The stuff on the igniter may be hardened carbon from a poor flame. Bottom line is some burner work. A new mat, ring and cleaning the burner air holes is in order. Don't be surprised if the heat chamber is cracked beyond repair when you get it off. NOW for the bad news. The Laser 55 and 72 are older heaters. You will find just about all the electrical parts are going to be hard to find. They are no longer being made. Your 55 will be able to use the newer 56 blower, mat and burner ring. You will also be able to use the heat element off a 56 as well. If there is a problem with the fuel pump causing your poor flame you will be out of luck.

Good luck,

Tom Hawkins
hawkins111@gci.net




Mar 02, 2009 | Rinnai Toyostove Direct Vent Heater: Laser...

1 Answer

Propane gas burner now has red flame instead of blue


Hi, If you have the same problem with your stove , furnace and water heater, Then you look for things in common that would cause the problem. Any change in the flames is an indication of a change in the fuel/air mix. The item that would be common to all would be the pressure diaphragm. This is not something a customer should work on without a through knowledge of how they work. I think you would be well advised to have a service call. Good Luck!

Feb 10, 2009 | GE Profile Spectra JGBP90 Gas Kitchen...

1 Answer

My new gas stove (propane) is releasing black soothe when lit. All the pots are covered in this black powdery like substance. Whats the problem and how can i fix it. It's really costing me a lot to clean .


All gas stoves are set up for natural gas. Before using on propane, the oven and burners need to be converted for propane operation. Refer to the installation manual for conversion requirements for your particular stove.

Dec 25, 2008 | Kitchen Ranges

1 Answer

Change from lp to propane on my whirlpool stove


Propane is LP...(i.e. Liquid Petroleum)

The burners are working only as a fluke. It is extremely dangerous to operate a natural gas stove on propane. STOP USING IT IMMEDIATELY. Call your local propane supplier and ask them about converting it to LP/Propane.

Jan 15, 2008 | Frigidaire FGF326AS Gas Kitchen Range

1 Answer

GE XL44 and soot from burners


propane burns very dirty.you need to remove the burners and orfices and clean them good with oven cleaner.make sure their rinsed and dried well before installing,this should solve your problem.

Nov 08, 2007 | GE Profile Spectra JGBP90 Gas Kitchen...

2 Answers

Gas conversion


change the gas valve and burner orfice

Oct 26, 2007 | Kitchen Ranges

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top American Range Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

paulcarew

Level 3 Expert

2458 Answers

Are you an American Range Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...