Question about Frymaster Kitchen Appliances - Others

1 Answer

Frymaster piliot went out and I need to re light it

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 29 Answers

Turn gas valve to off for 5 minutes, then turn to pilot and push in and hold then light pilot light, release slowly and turn to on.

Posted on Jul 16, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change the pilot light thermocouple on my frymaster


the bottom cover may reveal it. It may need the shell removed. Look for tine screw to remove to release it.

Jan 19, 2017 | Frymaster Kitchen Appliances - Others

1 Answer

NEED MANUAL FOR FRYMASTER MODEL MJH50BLCSC


Hi there.
Try seaching for manual at http://www.frymaster.com
Regards.

Jun 16, 2012 | Kitchen Appliances - Others

1 Answer

I need manual


Hi,
You can download the manual for your Frymaster Dean H14 on their site: http://www.frymaster.com/?xhtml=xhtml/fry/us/en/general/manuals.html
Hope that helps!

Oct 18, 2010 | Frymaster Dean H14BL Deep Fryer

1 Answer

Frymaster will not re-light after reaching temp on initial start


You have a lazy thermostat that needs replacing. Not uncommon.


Tom

May 21, 2010 | Frymaster Dean FM345EETC Deep Fryer

1 Answer

I need to know how to lite the pilot on my frymaster fryer


fry099_16_4.gifMake sure the thermostat is turned off. Units burners will light as soon a pilot in it is on. fry099_16_5.gif 3-2 Lighting the Pilot and Burner Figure 1 Figure 2 3. Push the knob in and light the pilot. Continue to hold the knob in for about 60 seconds after the flame appears on the pilot. Release the knob. The pilot should remain lit.

I suggest that you boil it out before using. This cleans the pot of any contaminants here is how to do this.
Boiling Out the frypot To ensure that the frypot is free of any contamination resulting from its manufacture, shipping, and handling during installation, the frypot must be boiled out before first use. Frymaster recommends boiling out the frypot each time the oil or shortening is changed. 1. Before lighting the burner, close the frypot drain valve and fill the frypot with a mixture of cold water and boil-out solution or detergent. Fill to the lower oil-level line. 2. Light the fryer in accordance with the lighting instructions in Section 3.1. 3. Simmer the solution for one hour.
I would attempt to paste the complete owners manual but it's just way to large. I do warranty for Frymaster is how I have access to it. Good luck

Oct 17, 2009 | Frymaster Dean GF14 Deep Fryer

1 Answer

I have a frymaster model mj35ssp cannot find where to light the pilot light at! Can someone please tell me


If you forward your e-mail address I will send you the Frymaster instructions w/ picture of where to light the pilot.
Rick
capt_rick1912@yahoo.com

Jul 21, 2009 | Frymaster Dean MJ35-SC-1 ''Standard'' Deep...

1 Answer

Raypak pool heater piliot light on heat will not turn on


Make sure that gas control knob is set to ON (counterclockwise). Make sure that ON/OFF switch is ON. Check that temperature setting is high enough to call for heat. Make sure pool pump is running and water is flowing to unit.
If not above there is a diagnostic procedure on page 33 of manual at:
http://www.raypak.com/uploads/6000.52AG.pdf

May 24, 2009 | Raypak Rp2100 Pool & Spa Heater Lonox 407k...

1 Answer

Honeywell water heater. It's about 2 1/2 years old. I went to press the red button because the water was cold and it never got hot. The pilot is completely off and it won't go on after I press the red...


turn the gas valve button to piliot position, push it down and hold it, click the ignitor to light it... look thru the site glass to see the spark all at the same time, if it lights hold the button on the gas valve down for 30 seconds, let it up if it doesn't stay lit you need either a thermo coupling or a gas valve thermo coupling would be the first choice, the is also a filter around the bottom of th tank near the floor it needs to be clean that is the only soirce of air to run the heater

Apr 21, 2009 | Water Heaters

Not finding what you are looking for?
Kitchen Appliances - Others Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frymaster Kitchen Appliances - Others Experts

paulcarew

Level 3 Expert

2461 Answers

richie46

Level 3 Expert

12833 Answers

ray gallant

Level 3 Expert

43006 Answers

Are you a Frymaster Kitchen Appliances - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...