Duet Sport. Will not start in any setting.

First, check the door switch. Push and release it by hand and you should hear a click. If no sound, replace the door switch with this part.
If the switch is ok, press the cancel button on the machine. Then do this. press and hold the start button for 2 seconds then release wait 2 seconds and press and hold again for 2 seconds continue this pattern until the dryer goes into test mode. You will see all the lights on the control light up. press each button on the control one at a time 3 times each. (Do not press the cancel button) until the dryer begins to run. When the dryer starts to run then press the cancel button. Then your machine should function properly.

Get the top off there and check the mechanical arm on the dispenser motor. then check that motor. F-30 = dispenser failure.

DUET SPORT SERVICE MANUAL

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Duet sport dryer service manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hello,

Very common issue, check the door switch when you press it in you should hear a click, If you have a volt meter we can walk you through this repair.

http://www.appliancerepairlesson.com/

the soft touch button switch is stuck up

I had the same problem. My control lock was on without the status light on. To unlock the controls I Selected and held END OF CYCLE SIGNAL button for at least 3 seconds. The lock/unlock control status light never indicated the locked position, yet my washer now works. NOTE: Select and hold END OF CYCLE SIGNAL button for 3 seconds to toggle between lock and unlock.

check door "close"contact button/switch usually the culprit..

sounds as if its a door latch/lock issue, not recognizing the door closed will simply beep 3 times when the start button is depressed. try unplugging and replugging after 2 min.

If it sounds like the timers clicking but not turning on you might have a bad thermal fuse.

Holding the End Cycle button for a few seconds worked! Yes