CLOTHES ARE STILL WET AFTER SPIN CYCLE

Check and choose a longer spin cycle and see if the fault changes. If so the SPIN cycle is too less or there is less action or speed in the cycle, check the motor speed, check the capacitor to the motor, the spindle friction - if so reset the spindle and drive.

check the Lid safety switch, if its shorted the spin cycle won't work, so your left with wet clothes ,, you can jumper the 2 wires together to test the switch , if that makes the cycle work, Replace that switch

IF ITS A TOP LOADER YOU MAY HAVE A BROKEN LID SWITCH. LOOK DON THE HOLE IN THE TOP WHERE THE LID PIN GOES CAN YOU SEE THE LID SWITCH ARM? IF ITS NOT FLUSH WITH THE HOLE ITS BROKEN. SOMETIMES YOU CAN STICK SOMETHING THROUGH THE HOLE TO ACTIVATE IT

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

there should be 2 or 3 springs that hold it, they mite have broke, take off back panel an check.

I assume this is a top loader, check the lid switch, you should hear it "click" when the lid is lifted. If no click the switch is broken.

if it has a belt, it may be slipping, but you would smell a bit of burning rubber.in high use times(4 to 8 pm), the current of electric supply is low, thus less power. third, motor may need to be replaced. plz rate-bozcro

Dear Customer

Please perform the following

Clothes are too wet after spin cycle:
This may be a spin problem or a drain problem
Drain:

• Make sure the drain line is clear
• Check the drain hose for a partial blockage
• Inspect the water pump

Spin:

• Test the lid switch
• Test the timer control
• Test the centrifugal switch
• Test the water level switch
• Inspect the motor coupler
• Inspect the drive belt (belt drive only)
• Inspect under the washer for soot (clutch)
• Test the motor
• Inspect the pulley
• Test the transmission

Please rate this,Thank u

you need to check the lid switch ...Set the unit to the spin cycle and open the lid look on the right side for the switch there ia a finger on the lid itself that closes to this with the lid open and the unit on use a pen to press in on the switch you should hear a click if not the switch is bad and will need replaced

HP, sounds like your washer is not going through the neutral drain. After agitation the tub should drain for about 90 seconds before going into spin. You can verify this by doing a load with the lid up and holding the lid switch down with a small screwdriver. If it fails to go into the neutral drain, it's a gearcase problem and should be covered under warranty for 5 years. If it does go into the neutral drain, then it's another issue such as the pump or drain hose....Catriver..post back