Question about Sony KV-36XBR400 36" TV

Open Question

My sony xbr 400 sounds like its going to turn but no picture red

My tv sounds like its going to turn on when power Burton pushed bit no icture red light bli nks5 timeafter a couple dataa then turba on where or i

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: SONY 36 XBR SOUND BUT NO PICTURE

posible solution is adjust the screen to low.also check the trimer if it is working.check the resistor in the heater line...weng

Posted on Dec 29, 2007

  • 9 Answers

SOURCE: RE: Flashing "Standby" light

Go here http://www.avsforum.com/avs-vb/showthread.php?t=928945&page=4
for my post #108 for a step-by-step solution with pictures. $21.83 is all it cost me. I fixed my own TV as many others on that forum have. Feel free to contact me at eclipsedave@yahoo.com if you run into difficulties.
-Dave

Posted on May 12, 2008

  • 4234 Answers

SOURCE: Sony Trinitron XBR, Stand By Mode?

The 6 or 7 blinks usually indicate a problem in the horizontal circuit. Since the TV recovered once, the problem is most likely to be a bad solder connection in that area. If you can solder, resolder any connections on the board that appear grainy or have rings. That may resolve the problem. If not, update this and we'll look elsewhere for defective parts.

Dan

Posted on Sep 16, 2008

jingjao
  • 252 Answers

SOURCE: Sony Trinitron KV-24FS100 red light flashes 4 times

your tv had a problem.if you have a knowledge in electronics, check or replace the horizontal transistor beside the plyback. it is a black square parts with 3 pins.

Posted on Oct 14, 2008

  • 4 Answers

SOURCE: Sony Trinitron XBR TV, picture-in-picture got

A solution I found for our KV-32XBR200 was to press Setup on top of the set, then select the "Demo" item with TV/Video. The text overlay apparently banished PIP. Verified this twice, as I'm at this page because our remote can only turn PIP on :-).

Posted on Feb 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony led tv picture black and won't turn on. I've unplugged it. Reset it. Only thing I can get is sound.


Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Dec 08, 2016 | Sony Televison & Video

2 Answers

Sony bravia xbr has red vertical lines going through it


Try changing the input device to something you are sure, works such as a DVD player. Switch off TV manually, switch off power, remove plug and retry after 48 hours. If problem persists, please refer it to a qualified service technician.

Jul 31, 2012 | Sony BRAVIA XBR 52 in. LCD Flat-Panel HDTV

1 Answer

Sony XBR 40" tube tv.


Failure of the vertical deflection module/circuit. The tv will have to be opened, the vertical deflection circuit found and replaced.
Definitely a job for a pro - the circuit is going to be extremely difficult to extract. The repair will cost you about $200: $20 for a new circuit and $90 per hour for the 2 hour job.

Sep 03, 2011 | Sony BRAVIA KDL-40S2000 40 in. LCD HDTV

1 Answer

Hi. My Sony Videoscope XBR's Convergence Allignment


I happen to share this same problem. The alignment of the gridlines on the standard convergence panel are completely abnormal, and if I attempt to auto-adjust the TV, it flashes different colors on the sides of the screen , and then turns off the convergence settings.

Feb 01, 2010 | Sony Televison & Video

1 Answer

No picture or sound when powered up. Red Standby light flashes continually. My Sony KV 36 XBR250 Wega Trinitron XBR is about 10 years old and has worked perfectly up to this point. What could be the...


Did you get your set fixed or did you replace it? My same set did the same thing. Turned it off for 2-3hrs after watching it and when I tried to power it up- nothing but the sound it would normally make just before the major power up, sort of a relay click sound. No picture or sound but the red light blinks non-stop.

Jan 20, 2010 | Sony KV-36XBR250 TV

1 Answer

Sony Trinitron XBR TV, picture-in-picture got


A solution I found for our KV-32XBR200 was to press Setup on top of the set, then select the "Demo" item with TV/Video. The text overlay apparently banished PIP. Verified this twice, as I'm at this page because our remote can only turn PIP on :-).

Dec 24, 2009 | Sony Televison & Video

1 Answer

I have a Sony Bravia XBR 46". It is 18 months old. The left 20% of the picture is fine, but the right 80% flickers in horizontal bands. Pushing back lightly on the upper right corner of the bezel and...


Please make sure that the connections are secure.


If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.

Please try connecting the TV to a different wall outlet and check if that helps.

Jun 19, 2009 | Sony BRAVIA XBR KDL-V26XBR1 26 in. LCD...

1 Answer

No picture but hear the fan on


does your power light blink red 3 times?

Feb 17, 2008 | Sony Grand WEGA KDF-60XBR950 60" Rear...

1 Answer

Sony 57 Inch XBR 2001


I don't have the XBR, but on my sony, using the cable box remote, I had to go into menu/display/etc. and mark the 1080i, 720p, and 480i settings. you usually get a "if you can see this" comment if your tv accepts the settings. for standard tv i set the screen to normal, and when the upper channels go to HD, they auto go to full screen. Sounds like you are using the component cable, and also make sure you are on the video port of remote, and the the TV input. The above worked for mine. Hope it helps.

Dec 04, 2007 | Sony KP-57XBR10 57" Rear Projection...

1 Answer

SONY 36 XBR SOUND BUT NO PICTURE


posible solution is adjust the screen to low.also check the trimer if it is working.check the resistor in the heater line...weng

Oct 30, 2007 | Sony FD Trinitron WEGA KV-20FS120 20" TV

Not finding what you are looking for?
Sony KV-36XBR400 36" TV Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

kakima

Level 3 Expert

102366 Answers

The Knight
The Knight

Level 3 Expert

73647 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1667 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...