Question about Mitsubishi VS-70601 70" Rear Projection Television

2 Answers

What is the second top screen

Is their a place were you can get another extra top screen?

Posted by on

2 Answers

Re: what is the second top screen

If you are talking about the grey one with ridges, that is the lenticular lense they do not make it anymore anywhere, only suggestion is to look for broke tv to get it or ebay or craigslist.

Posted on Aug 13, 2007

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,130 Answers
Re: what is the second top screen

Are you talking about the clear protector screen on the outside of the TV set?

Posted on Aug 04, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Screen replacement hdtv

As i can see it should be easy to do. need to unscrew the back, then unscrew the cage and pull away then the screen is there sna you can replace it from there without having to remove any boards just remember there is a mirror inside the case at the top its only got glue holding it in its place. so take out carefully and place some were so it will not get damaged. the screen has a bazle holding it in place these can be brittle so take care removing it. as iv never seen a replacement one for any tv with them fitted. you can glue the screen in place but you can somtimes leave a mark and it will show up when the tv is on.

Oct 21, 2013 | Hitachi UltraVision 60VF820 TV

2 Answers

Top 1/3 of screen flickers & is darker at edges of screen

You have what we call an intermittent connection internally. This is usually a cold solder joint, loose wire or corroded pin inside a connector.

They are usually very difficult to find, but once you find them, the are easy to fix.

You can try the Whacking procedure: Just bang around a few places with your fist to see if you can stop it. Try putting a book or magazine under one corner or another to see if the extra torque or twist on the chassis will get rid of it.

In the worst case you can take of the back cover and start probing around inside. If you take it to the repair shop they will charge you lots of labor because they must spend along time tracking it down.

If you want to try getting inside and finding it, please let me know and I will give you some step by step procedures on how to do it and how to avoid getting tangled up with the 35,000 volts inside your set!

May 14, 2009 | Mitsubishi WT-46809 46" Rear Projection...

1 Answer

Picture and sound go off for a few seconds and then come back on.

When the bulb goes off with the sound. The lamp is starting to fail and you need to replace it. Wear gloves when replacing the lamp. Use XL-2400(part # F93087500) replacement lamp. For information visit for US residents and forCanada residents.
  1. Remove the outside lamp cover.
  2. Turn the knob counterclockwise to OPEN and pull out the cover.
  3. Hook a finger through the loop of the lamp handle and pull the handle upwards then pull the lamp straight out.
  4. Putthe new lamp in its place. Mount it securely and take extra care not totouch glass portion of the lamp.
  5. Turn the knob back to CLOSE and secure the cover.
  6. Put the outside lamp cover back in its place.
  7. Turn on the TV
  8. Browse MENU>SETTINGS>SET-UP>Lamp Replacement then follow the on-screen procedure.
NOTE:Dispose the used lamp properly. It contains mercury and disposal isregulated..Contact your local authorities for proper disposal.

Aug 23, 2009 | Sony Projection Televisions

1 Answer

I need to clean my 1997,52 inch rca tv screen

Take the screws out of the BACK top panal of tv! be gentle the mirror is connected to this back!.... now after removeing back you will see the inside of screen and the three lenses and on back panel the mirror! clean all three of these and you will see a big change for the better..Then just replace back! (The screen itself does not come out!)
Please take a second to place a rating for my answer!
thank you!

Jan 26, 2009 | Panasonic PT-47WX49 47" Rear Projection...

1 Answer

My Hitachi 53 inch projection tv screen is warped...colors off

Good Luck on find screen ask all your local tv repair shops if they have one your size cost anywhere from150.00 up to 500.00.

Dec 01, 2008 | Hitachi 53UDX10B 53" Rear Projection...

1 Answer

Screen replacement??

screens are quite expensive relative to the tv.. is the screen busted completly or just the top plasitic/ averge part cost are around 250 to 350 for the set of screens... places like union electronics is the place where my shop gets rca parts. not difficult to replace. you need the complete model number like hd52w59yx1. to get the correct replacement

Oct 31, 2008 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer


Go to this link and click on the contact linkon the lower left side of the home page and leave the measurements of your screen top to bottom and side to side. They have used assemblies just measure what you see right up to the edge of the frame and they will add the extra 1/4 inch for whats inside the frame.

Apr 07, 2008 | Hitachi 50FX48B 50" Rear Projection...

1 Answer

Mitsubishi vs-50603 removing screen for cleaning

You were in the right place going at it from the front. After removing the grill the bottom edge of the screen has a series of screws holding the lower edging down. Remove the screws and gently but firmly work the sides of the screen frame up to unlatch the top. When you have the screen/frame in your hand just be careful not to go to far with it - wires attaching the panel controls are still attached and don't have a lot of extra length.
Clean the cans, mirror and reverse area of the lenticular screen and re-assemble.

Mar 11, 2008 | Mitsubishi VS-45607 45" Rear Projection...

2 Answers

Need to replace a cracked screen

WD-57731 & WD-65731 Front Disassembly
57” & 65” Models Screen Frame
1) Pull off the Speaker Grill.
2) Remove all the screws (b) from the
upper rear cover (except one at an
upper corner to support the frame).
3) Remove 10 screws (a) from the
front of the screen frame.
4) Remove the remaining ***** (b)
(supporting the frame). Carefully
pull the Screen Frame from the TV
and disconnect the ES and LE
57” & 65” Models Screens Removal from Frame
1) From the rear of the Screen Frame remove 20 screws (a) from the top and bottom rails
2) Remove 6 screws (b) from each side rail.
3) Carefully lift the Screen assembly from the Frame.

MODEL: WD-52631 / WD-57731 / WD-65731
Screen Replacement
CAUTION: Wear gloves when handling the Lenticular Screen and Fresnel Lens.
This prevents cuts and finger prints. Do not place Fresnel Lens in the sun.
This may cause fire and heat related injuries.
Lenticular Screen and Fresnel Lens Replacement
1) Apply LENS-TAPE along the rear top edge of the Lenticular Screen.
2) Place the Fresnel Lens on top of the Lenticular Screen, and apply pressure along the top edge.
3) Place the screens in the screen frame and reinstall the cushions, top, bottom and side rails.
NOTE: The Lenticular Screen label must face the front and the Fresnel Lens label face the rear.
4) Reverse the Screen Removal Procedure and insert the screens in the Bezel.
Lenticular Screen and Fresnel Lens Removal
1) Remove the top, bottom and side HOLDER-SCREEN rails and their cushions from the Screen Frame.
2) Lift the screens as a single unit from the frame.
2. Separate the Lenticular Screen and Fresnel Lens.
Note: When separating the Lenticular Screen from the Fresnel Lens, use caution
while prying the Screen and Lens apart. Use a slot type ***** driver, and
remove the pressure sensitive double sided tape.

Mar 11, 2008 | Mitsubishi WD-65731 65" HDTV

1 Answer

TV shuts down

Remove the lamp assembly, There will be a screen on the top and bottom of the assy remove all dust from these screens. also check the tube at the top of of the lamp receptical this is an air cooling pathway. reassemble and fire it up. This worked for me and saved some serious coin judging from some of the other solutions I have seen (lamp and balast) ouch!!!

Jun 21, 2007 | Sony Grand WEGA KDF-60WF655 60" Rear...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Projection Televisions Experts

matt martin
matt martin

Level 3 Expert

1187 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

The Knight
The Knight

Level 3 Expert

66552 Answers

Are you a Mitsubishi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides