Question about Xerox Phaser 7300DN Laser Printer
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: xerox phaser 7400
Remove the tray, first look for a piece of paper that has come out of the tray inside the tray area.
Make sure the rolllers are snapped into place. The easiest way to verify that is to remove another tray and compare them.
Look to see if all the switches and actuators are in place.
Make sure you hear the tray up motor running when you close the tray.
Also inspect the paper tray itself for broken items. Compare it to another tray.
Posted on Feb 04, 2008
SOURCE: phaser 7400
i have a phaser 7400 printer when i turn on the printer it say cyan led error turn off printer and turn it back on. It keep on giving me this message what should i do. Another thing is that a gear on the waste cartridge is broken is there a way i could fix it without getting a tech to come look at it. It alway say waste toner is full, ( replace it) which i already did. What should i do?
Posted on Mar 14, 2008
SOURCE: PRINTER ERROR
There is a tiny little magnet that falls off and/or has reportedly been put on backwards (fell off is what happened to me) on the auger assembly. It's near the black auger chute on the end of a shaft. It's tiny--a little bigger than a grain of rice. I had to replace the auger shaft assembly but if you can find the magnet, you can super glue it back on.
Posted on Jan 17, 2009
there is a stainless steel print head block on the lower back portion of the frame that gets contaminated with spill over ink from the catch tray. That causes the print head not to move properly.
The wiper blade may also be tacked to the print head.
That code means the print head is not moving into the print position properly.
That stainless steel block is about 1 inch square.
Posted on Mar 11, 2009
Job Offset Home Position Sensor does not detect home position for the Job Offset Assembly.
Check the following for evidence of fault or
■ Home Position Sensor Actuator
■ Home Position Sensor
■ SNS Harness
Is there any damage or misalignment?
parts that need to be changed if still no fixed.
Offset Home Position Sensor
Rear Sensor Board
Job Offset Assembly,
hope this helps.
Posted on Dec 17, 2009
Tips for a great answer:
Jan 13, 2012 | Xerox Office Equipment & Supplies
Jan 17, 2011 | Xerox Phaser 7400/DXF Laser Printer
Jan 05, 2011 | Xerox Phaser 7400/DXF Laser Printer
Sep 23, 2010 | Xerox Phaser 7400/DXF Laser Printer
Jul 01, 2010 | Xerox Phaser 7400DN Laser Printer
Apr 16, 2010 | Xerox Phaser 7400DN Laser Printer
Oct 29, 2009 | Xerox Phaser 7400/DX Laser Printer
Oct 13, 2009 | Xerox Phaser 7400/DXF Laser Printer
91 people viewed this question
Usually answered in minutes!